J8
© 2008 AS America Inc.
RETROSPECT COLLECTION
®
PEDESTAL SINK
FIRE CLAY
RETROSPECT COLLECTION
®
PEDESTAL SINK
• Authentically styled rectangle pedestal
• Made from ne reclay
• Generous deck area for toiletries
• Hidden front overow
• Supplied with mounting kit
• Right Height™ for greater comfort
• Part of design matched Retrospect Collection
®
❏ 0282.800 Faucet holes on 8" (203mm) centers
Nominal Dimensions:
27" x 19-3/4" x 36"
(686 x 502 x 914mm)
Separate Components:
❏ 0282.008 Pedestal top 8" (203mm) centers
❏ 0066.000 Pedestal only
Bowl sizes:
15-1/2" (394mm) wide
12" (305mm) front to back
6-1/8" (156mm) deep
Compliance Certications -
Meets or Exceeds the Following Specications:
• ASME A112.19.9M for Non-Vitreous
Ceramic Fixtures
• CAN/CSA B45 Series
NOTES:
*
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE
SUGGESTED.
▼ PEDESTAL ANCHORING SCREWS NOT INCLUDED.
■ SUITABLE FOR REINFORCEMENT ONLY. ACTUAL DIMENSIONS MUST
BE TAKEN FROM FIXTURE.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
INSTALLATION INSTRUCTIONS SUPPLIED WITH LAVATORY.
IMPORTANT: Dimensions of xtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.9.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided pages.
FINISHED WALL
PEDESTAL
SIDE SECTION
*
*
1-1/4 O.D.
WASTE
SUPPLIES
AS REQ'D
FINISHED
FLOOR
9"
(229mm)
19-3/4"
(502mm)
27"
(686mm)
8"
(203mm)
13-3/4"
(349mm)
3-3/8"
(86mm)
PED TOP
OUTLINE
1-3/4" DIA.
STD. DRAIN
OUTLET
3/8" (10mm) DIA.
BASE ANCHOR
SCREW HOLE
CENTER
3/8" (10mm) DIA.
SINK ANCHOR
SCREW HOLES
ON 13-3/4" (349mm)
CENTRES
36"
(914mm)
28-1/4"
(718mm)
7-1/4"
(184mm)
8-1/8"
TO BOTTOM
OF DRAIN OUTLET
(206mm)
9-7/8"
(251mm)
24"
(610mm)
22"
(559mm)
1-1/4" O.D.
TAILPIECE
8"
(203mm)
3 Holes
1-3/8" (35mm) Dia.
15"
(381mm)
To Be Specied:
❏ Color: ❏ White
❏ Recommended Faucet: 2373.701
❏ Faucet Finish:
❏ Supplies:
❏ 1-1/4" Trap:
Revised 2/08