Smart Touchless Vac-Can
User Manual
Model VK-9108A
Item 58034
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
1
IMPORTANT SAFETYINSTRUCTIONS
This electrical appliance must always be used according to the following safety instructions.
Save these instructions as this manual contains important safety and operating information.
When using an electrical appliance, basic precautions should always be followed, including:
READ ALL INSTRUCTIONS CAREFULLY BEFORE
USING THE APPLIANCE
WARNING! To reduce the risk of fire, electrical shock, or injury:
1. Always turn the power OFF before unplugging.
2. Always unplug the appliance before cleaning or servicing. Do not unplug
by pulling the cord; to unplug, grasp the plug, not the cord.
3. Do not let the appliance be used as a toy. Close attention is necessary
when used near children. Do not use in AUTO mode or leave appliance
plugged in near small children or infants.
4. Do not pull or carry the appliance by the cord. Keep the cord away
from heated surfaces.
5. Do not use the appliance if the cord or plug is damaged.
6. Do not handle the plug or appliance with wet hands.
7. Do not use appliance on wet surfaces.
8. Do not expose to rain.
9. Do not use appliance to dispose of water or damp materials such as mud,
tile gout, plaster filter, or caulking. Do not use to vacuum any liquid or wet
objects.
10. Do not use this appliance to vacuum up burning or combustible liquid,
such as gasoline. Do not use in areas where these liquids may be present.
11. Do not use this appliance to vacuum up burning or smoking materials,
such as cigarettes, matches or hot ashes.
12. Keep hair, loose clothing, and all parts of the body, fingers, away
from openings and moving parts.
13. Do not force any objects into appliance openings.
14. Do not use this appliance to vacuum hard or sharp objects or large
surface litter. Pick these up by hand before vacuuming.
15. Do not operate without the Collection Bin properly in place.
16. Use the appliance only as described in this User Manual.
17. Turn the appliance off and unplug before removing or replacing the
inner Collection Bin or filter.
18. Unplug appliance before cleaning or maintenance.
19. If the appliance is not working as it should, review the Trouble Shooting
section on page 6, and then call for instructions where to send for repair.
Do not attempt to repair, as it will invalidate your warranty.
20. When cleaning the outside of the appliance, wipe with a damp cloth
to reduce the static electricity on the outer surface.
WARNING: In order to prevent electric shock, do not use on wet
surfaces. Do not expose to rain. Store indoors.
2
DESCRIPTION OF SMART TOUCHLESS VAC-CAN
A. Lid
B. HEPA Filter
C. Collection Bin
D. Control Panel
E. Infrared Stay-
Open Sensor
F. Manual Vacuum
Kick-Switch
G. Infrared Vacuum Sensor
H. Dirt Inlet
I. Lid Sensor
J. Air Outlet Filter
K. Filter Holder
L. Power cord
3
CONTROL PANEL DESCRIPTION
Image # Display Description
1 POWER
Press to turn unit on. Press again to
cycle through modes. Hold for 3
seconds to turn unit off.
2 AUTO Automatic vacuum mode
3 MAN Manual vacuum mode
4 FULL Collection Bin full indicator
5 START/OFF Press to start or stop vacuum cycle
6 OPEN Press to open trash can lid
7 CLOSE Press to close trash can lid
8
INDICATOR
LIGHT
Blue – Trash can lid open
Red – Trash can lid closed
4
BEFORE FIRST USE
HEPA FILTER AND TRASH BAG INSTALLATION
1. Remove the included HEPA filter from plastic bag and install it into Collection
Bin’s filter slot with flaps facing upward.
2. Remove Collection Bin and unlock side clips to
separate the upper part from the bottom part of
Collection Bin. (see fig. a & b)
3. Insert any appropriate sized trash bag into the
bottom part of the Collection Bin. Re install the
upper part of the bin and lock in place with side
clips. Replace Collection Bin into the trash can.
The trash can is ready for use.
SENSOR TRASH CAN OPERATION INSTRUCTION
1. Press the POWER button to turn the unit on. A Blue Indicator Light under AUTO
will illuminate indicating the unit is on and ready to use.
2. Place your hand or any object 4 – 12 inches above Lid
Sensor to open trash can lid automatically. (see fig. c) The lid
will remain open if Infrared Sensor in front of the trash can
detects people or object within its range.
3. To manually open and close trash can lid, press OPEN and
CLOSE buttons.
4. When the Collection Bin is full, the indicator light FULL will
flash and beep audibly.
5. Utilize Infrared Sensor or press OPEN to open the trash can lid. Follow TRASH
BAG INSTALLATION steps above to remove and replace the trash bag.
Note: Trash can lid will not open during a vacuuming cycle.
VACUUM OPERATIONINSTRUCTION
1. Press the POWER button to power on. A Blue Indicator Light under AUTO will
illuminate. The vacuum defaults to Auto Mode for automatic use when turned on.
2. Sweep debris toward the inlet at the base of the unit. The infrared sensors will
detect the debris and automatically initiate a timed vacuuming cycle of 5 seconds.
3. Activate Manual Mode by pressing the POWER button again. The Blue Indicator
Light will illuminate under MAN. Sweep debris toward the inlet at the base of the
unit, press the START/OFF button or gently tap the Manual Vacuum Kick-
Switch to start and stop vacuum.
Note: You may utilize the manual vacuum Kick-Switch to start and stop vacuum
cycle during Auto or Manual Mode.
fig. c
fig. a
fig. b
5
COLLEC
TION BIN CLEANING INSTRUCTIO
N
1. Press and hold the POWER button for 3 seconds to turn off
the unit. Unplug Power Cord from AC outlet.
2. Open trash can lid, lift handle to remove Collection Bin from
the unit.
3. Unlock side clips and remove trash bag(Refer to Trash Bag Installation
instructions above).
4. Wash Collection Bin by hand in warm water with mild soap. Avoid using harsh
chemical or abrasive cleaning material. Rinse and dry thoroughly. The
Collection Bin is NOT dishwasher safe.
5. Gently clean sensors and dirt inlet area with a damp cloth. Do not scrub or use
abrasive cleaning materials.
6. Replace Collection Bin back into the unit. If Collection Bin is improperly installed,
an audible Beep will sound once the unit is plugged in and powered back on.
HEPA AND AIR OUTLET FILTERS CLEANING INSTRUCTION
It is recommended to clean the HEPA and Air Outlet filters periodically to keep the
Smart Touchless Vac-Can operating at peak performance. Poorly maintained HEPA
and Air Outlet filters may collect debris to cause obstruction in vacuum’s air flow and
significant degrade performance.
1. Press and hold the POWER button for 3 seconds to turn off
the unit. Unplug Power Cord from AC outlet.
2. To remove HEPA filter, open trash can lid, lift and remove
HEPA filter from its housing. (see fig. a)
3. To remove Air Outlet filter, press the filter holder in the back
of the unit, the holder will pop open. (see fig. b& c)
4. Rinse both filters under cold running water for two
minutes until water runs clear and filter is clear from
any visible debris.
5. Dry filters thoroughly before inserting back into
housing placements.
IMPORTANT! NEVER OPERATE THE MACHINE
WITHOUT HEPA OR AIR OUTLET FILTER PROPERLY IN
PLACE.
fig. a
fig. b
fig. c
6
STORAGE INSTRUCTION
1. Press and hold the POWER button for 3 seconds to turn off the unit. Unplug
Power Cord from AC outlet.
2. Thoroughly clean the unit by follow Collection Bin Cleaning Instructions and
HEPA and Air Outlet filter cleaning instructions on page 5.
3. Unplug Power Cord from the back of the unit and store it inside Collection Bin.
Never wrap cord tightly around the unit, bending cord in sharp angles may cause
breakage.
4. Store the Smart Touchless Vac-Can indoors in a clean, dry place. Never store
the unit when it is still plugged in.
WARNING! TO AVOID ELECTRIC SHOCK, DO NOT USE THE SMART
TOUCHLESS VAC-CAN OUTDOORS OR IN WET SURROUNDINGS.
TROUBLE SHOOTING
Problem Possible Cause Possible Solution
Smart Touchless
Vac-Can does not
power on
1.
Not firmly plugged in
2. Unit is in off status
3. Collection bin is not in position
4. No power in wall plug
5. Blown house fuse or tripped circuit
breaker
6. Cover is not closed
1.
Plug in firmly
2. Press POWER button and switch
mode between AUTO and MAN
3. Reinstall Collection Bin
4. Check house fuse or circuit breaker
5. Have a qualified licensed electrician
replace house fuse or reset circuit
breaker
6. Press the close button
Does not run,
audible beep.
Collection Bin is n
ot in
-
place or
improperly placed inside the unit
Re
-
install the Collection Bin
correctly
Does not vacuum
1.
Dirt Inlet is blocked
2. Collection Bin is full
3. Debris too large for inlet
First power off unit
1. Clean path of Dirt Inlet
2. Empty Collection Bin
3. Clear large debris
Sensors do not
activate
Unit is not
on
AUTO mode
Press POWER button to cycle to AUTO
mode
Suction is not strong
Filters may be dirty
Clean both HEPA and Air Inlet filters
by follow filter cleaning instructions
on page 5
Trashcan Lid won’t
close
1.
Objects are detected
2. Collection Bin handle is improperly
placed
1.
Remove object
2. Swing Collection Bin handle to the
other side
7
Tenergy Corporation
436 Kato Terrace
Fremont, CA 94539
(510) 687-0388
Email: [email protected]
LIMITED WARRANTY
Tenergy warrants its product shall be free from defects in materials
and workmanship, under normal conditions and use, for a Limited
Warranty Period of twelve (12) months from the date of original
purchase. This warranty is not applicable to cases other than
defects in material and workmanship. This warranty is only valid
upon presentation of the proof of purchase which include the
original invoice or sales receipt indicating the date of purchase,
store name, model and serial number or UPC of the product. In no
case shall Tenergy Corporation's liability be greater than the actual
purchase price of this product. This limited warranty does not cover
normal wear and tear, water damage, or other alleged defect or
nonconformity that is a result of abuse, misuse, neglect, tampering,
unauthorized or improper use or installation, disassembly, repair,
alteration, or accident by Purchaser. Please make all warranty
claims to Tenergy Customer Service at Tenergy Customer Service at
/
