on. Jump ropes, leashes, cables etc. could pose a risk for strangulation.
● WARNING: Regularly check your tree branch, as well as the rose and swing itself, for splitting, fraying etc. A
properly installed swing should not cause any damage or grooves in the tree. We recommend replacing the
ropes every couple of years.
WARRANTY
Flybar warrants the original purchaser, that the product is free of defects in material and workmanship for a period
of one year from the original date of purchase. This warranty does not apply to defects of physical damage resulting
from abuse, neglect, improper repair, improper t, altercations, or use unintended by the manufacturer. If your product
is found to be defective in materials or workmanship within one year from the date of purchase, Flybar will at its
discretion, either repair or replace the product free of charge. Proof of purchase will be required.
INSPECTION AND MAINTENANCE
● The fre quency of inspection and maintenance will vary with the type of equipment or materials used. Additional
factors include heavy use, coastal locations, age of equipment etc.
● Carry out maintenance checks monthly or before the start of a usage period, checking more regularly in
seasons of high usage.
● Special attention should be given to the swing hooks, rings, eights, plastic welds and ropes. Moving metal
parts must be oiled regularly.
● Inspect nuts, bolts, and knots for tightness.
● Check that all accessories and parts are in proper working order.
For more information on playground safety, download the United States Consumer Product Safety
Commission’s Outdoor Home Playground Safety Handbook at no cost: https://www.cpsc.gov/s3fs-public/324.
pdf CHECK THE SWING BEFORE EACH USE, AND PERFORM MAINTENANCE REGULARLY. THIS
INCLUDES, BUT IS NOT LIMITED TO CHECKING THE SWING FOR CRACKS, RIPS, TEARS, BREAKS,
MISSING PIECES, EXCESS WEAR, LOOSE CONNECTIONS, DECREASED STABILITY AND OVERALL
INTEGRITY.
INSTRUCTIONS
Fast and easy tool free set up instructions.
1. Separate parts and lay out swing on the ground. Make sure to unfold the mat and alight the logo before you
proceed.
2. Notice the tubes have male and female ends. Place the plastic rope hub over the male side of the tube and
then insert the female side by depressing the small push button pin.
3. Listen for a “CLICK” and check to be sure the push button has popped back out and is holding the tubes
together securely.
4. Connect steel rings to secure anchor or tree swing strap carabiner.
5. Adjust the height of the swing by sliding the ropes up or down through the “s” rings on the rope.