Give the speaker stand a nice spot and
place the speaker on the stand. Conceal
the cable neatly through the groove in the
bar
.
You’ve finished! Or done, if you’re called Jan.
Secure the bar
to the floor plate
with the
bolts
and the large Allen key supplied
.
Make sure that the flat side of the bar
faces
forwards.
Tighten the speaker holder
with the
bolts
and the screwdriver
. Make
sure the notch is pointing backwards. is
is where you pass your cord through.
Loosen the top two small bolts that are already in the
bar
a little with the small Allen key
to adjust
the bar in height. ere is also a bolt at the bottom of
the bar: you can throw it away after loosening it.
Put the floor plate
upside down and
tighten the feet
. Do you have a carpet?
en use the spikes
instead of the
feet.
BBSSF22W
TIGHTEN THE FEET SECURE THE BAR
INSTALL SPEAKER
ADJUST THE BAR
1. 2. 3.
5.
SECURE SPEAKER HOLDER
4.
Levelling:
Make sure the speaker stand
is levelled. is will improve
the sound quality of the
speaker.
Load capacity:
Use the stand only for
speakers weighing a
maximum of 3 kg.
CHECKLIST.
You’re 50% there.
Do you have a question?
Coolblue.nl/en/
customer-service