Please read all instructions before using this mirror.
DANGER:
WARNING:
SAFETY INFORMATION:
MAINTENANCE:
Always unplug this mirror from the electrical outlet before cleaning.
To reduce the risk of electric shock:
1. Disconnect from outlet before putting on or taking off parts.
2. Close supervision is necessary when this mirror is used by, or near children.
3. Keep the cord away from heated surfaces.
4. Make sure that the electricity is turned off at the power source before proceeding
with the installation.
5. Always unplug all the power supply cords from before moving the product, testing
the product, or repairing the product.
6. Do not use outdoors.
1. Handle the glass with caution! Improperly handling the glass can cause it to break.
2. You will need at least two people to install this unit properly.
3. Seller is not responsible for any damage to the unit or personal property caused by
improper installation.
4. Install the product on a leveled surface.
√ For daily maintenance, use a wet cloth and a soft liquid cleaner.
√ Never use abrasive cleaners or strong bleach, scrapers, metallic brushes,
or other objects or any products which can graze or tarnish surfaces.
To reduce the risk of burns, fire, electric shock, or injury to persons:
HARDWARE
TOOLS REQUIRED
Pencil Rubber malletScrew driver
Safety glasses Drill and drill bit
3+1 3+1
CC
FULL LENGTH MIRROR
INSTRUCTION MANUAL
Sensor switch
Power cable
1. Place your hand about 5cm in front of the sensor switch
and swipe to control the light on and off.
2. Turn on and off the light in short time to control the color
of the light.
3. Put your hand in front of the sensor switch for a long time
to adjust the brightness of the light.
INSTALLATION GUIDELINES
1
2
AA
PLEASE NOTE
2
2
Option #1
1
12
1. Pick up your hands from both sides of the mirror, find a suitable angle, and lean the
mirror against the wall.
2. Connect the power supply (110V~).
3. Swipe the sensor switch to turn on the light. Your mirror is now ready to work.
Option #2
2
The mirror is fragile goods. If there is any problem of the mirror when you receive it,
please feel free to contact us via Amazon/eBay message. We will provide you with a
satisfactory solution. Thanks for your trust and support.
825
15
100V~120V
1. Measure the distance between the center points of the cross holes on the back of
the mirror. Use the ruler and pencil to locate and mark on the wall.
2. Use an electric drill to make holes at the mark.
3. Knock the expansion screws into the holes. Then knock the screws into the
expansion screws and leave a suitable length for hanging the mirror.
4. Turn off the power and then connect the electricity supply to the mains cable (110V~).
5. Insert a piece of screws left outside the wall into the cross holes on the back of the
mirror. Carefully attach the mirror to the wall, making sure the mirror hanging properly
and level.
6. Restore the power supply.
123
20*60*1.1 in
AC100~120V
12VDC 2.5A MAX
60W
SMD2835/432PCS
576lm
3000k-6500k
24W
AC110V
4
4
-
1
-
2
KINWELL UCD3015-15050 User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
LTL Home Products LI5096 Installation guide
-
-
lighted IMPRESSIONS LI8356 Installation guide
-
-
-
-
-
-
-
lighted IMPRESSIONS LI5102 Operating instructions
