Haier HWO60S7EX1 User manual

Brand: Haier

Model: HWO60S7EX1

Type: User manual

This manual is also suitable for

HWO60S4MX1

Haier HWO60S7EX1 is an electric built-in oven with a range of functions allowing you to bake, grill, and roast various foods. It features a temperature control knob, oven function selection knob, mechanical timer knob, and oven temperature signal light. The oven has a fan function for even cooking and can be used for defrosting food. Safety features include a child lock and automatic shut-off.

XBKXSH140113.01 BUILT-IN OVEN SALES SERVICE 第 1 页共 12 页

HWO60S4MX1 and HWO60S7EX1

Service Manual

XBKXSH140113.01 BUILT-IN OVEN SALES SERVICE 第 2 页共 12 页

INDEX

1. Safety and installation instruction

2. Part name

3. Oven function description

4. Common Faults Analysis and Troubleshooting

5. Replacement &Cleaning the door

6.Part change

7. Electrical schematics

XBKXSH140113.01 BUILT-IN OVEN SALES SERVICE 第 3 页共 12 页

一、 Safety instructions

1、 The appliance becomes very hot during opeiation.Take care not to touch the heating

elements inside the oven.

2、 WARNLNG:Accessible parts may become hot during use.To avoid bums young children

should be kept away.

3、 Mains lead of adjacent appliances may be damaged by hobs or stuck between the oven

doors,and produce short circuit,therefore keep them at safe distance from the

appliance.

4、 Never put pans weighing over 15Kg on the opened door of the oven.

5、 Do not use the oven in the event of a technical fault,once a technical fault

caused,disconnect the power and report the fault to the service centre to be repaired.

6、 Never clean the oven with the high-pressure steam cleaning device,as it may provoke

short circuit.

7、 Do not use harsh abrasive cleaners or sharp metal scrapers to clean The door glass as

they can scratch the surface,which could then result In the glass shattering.

8、 The rules and provisions contained in this instruction manual should

be strictly observed.Do not allow anybody who is not familiar with the

contents of this instruction manual to operate the oven.

9、 Lf the supply cord is damaged,it must be replaced by the manufacturer,

its service agent or similarly qualified persons in order to avoid a hazard.

10、 The appliance is not intended for use by persons(including children) with reduced

physical,sensory or mental capabilities,or lack of experience and knowledge,unless they

have been given supervision or instruction concerning use of the appliance by a person

responsible for their safety

11、 Children should be supervised to ensure they do not play with the appliance.

12、 WARNING:Ensure that the appliance is switched off before replacing the lamp to

avoid the possibility of electic shock.

13、 WARNING:The appliance and its accessible parts become hot during use.

14、 Care should be taken to avoid touching heating elements

15、 Children less than 8 years of age shall be kept away unless continuously

supervised.

16、 This appliance can be used by children aged from 8 years and above and persons

with reduced physical,sensory or mental capabilities or lack of experience and

knowledge if they have been given supervision or instruction concerning use of the

appliance in a safe way and understand the hazards involved.Children shall not play

with the appliance.Cleaning and user maintenance shall not be made by children

without supervision.

17、 WARNING:Accessible parts may become hot during use.

18、 Young children should be kept away

19、 During use the appliance becomes hot.Care should be taken to avoid touching

heating elements inside the oven

XBKXSH140113.01 BUILT-IN OVEN SALES SERVICE 第 4 页共 12 页

Installing the oven

1. The kitchen should be dry and airy and have effective centilation according to the

existing technical provisions.

2. Main lead behind the oven must be placed in such manner to avoid touching the

back panel of the oven because of the heat it develops during operation.

3. Remove any packaging materials (foils,artificial foam, nails, etc)from the reach of

children, because they represent pstential danger. Children may swallow small

parts, or suffocate with folls.

4. This is a built-in oven,which means that its back wall and one side wall can be

placed next toa high piece of furniture or a wall. Coating or veneer used on fitted

furniture must be applied with a heat resistant adhesive(100℃).This prevents

surface deformation or detachment of the coating. If you are unsure of your

furniture’s heat resistance, you should leave approximately 2 cm of free space

around the oven. The wall behind the oven should be resistant to high

temperatures. During operation, its back side can warm up to around 50℃above the

ambient temperature.

5. Make an opening with the dimensions given in the diagram for the oven to be fittde.

6. Make sure the mains plug is disconneted and then connect the oven to the mains

supply.

7. Insert the oven completely into the opening without allowing the four screws in the

places

shown in the diagram to fall out.

XBKXSH140113.01 BUILT-IN OVEN SALES SERVICE 第 5 页共 12 页

2、PART NAME

1. Temperature control knob

2. Oven function selection knob

3. Oven temperature signal light red

4. Oven door handle

XBKXSH140113.01 BUILT-IN OVEN SALES SERVICE 第 6 页共 12 页

5. Mechanical timer knob

3. Oven function description

Possible settings of the oven function knob

Full Grill (Grill and the top heater)

When the “combined grill” is active ,It enables grilling with the grill and with the top

heater switched on at the same time.

This function allows a higher temperature at the top of the cooking area,which

causes more intense browning of the dish and permits larger portions to be grilled.

Warning!

1,When using function Grill it is required that the oven door is closed.

2,When the grill is in use accessible parts can become hot.lt is best to keep

children away from the oven.

3,When using function grill it is Recommended that the oven door is Closed.

4,When the grill is in use accessible parts Can become hot.Lt is best to keep

children away from the oven.

Bottom and top heaters on

Setting the knob to this position allows the oven to be heated conventionally.

Bottom heater

At this oven function knob position,the oven activates the bottom heater.

Fan,bottom and top

Heaters on

At this knob position the oven executes the cake function.Conventional oven with

a fan.

Grill heater on

Setting the knob to this position allows dishes to be grilled on the grate.

Fan and bottom heater on

At this oven function knob position,the Oven activates the bottom heater ang fan

Function.

The mode is useful for baking low pastry Ang preparation of preserved fruit and

Vegetables.

XBKXSH140113.01 BUILT-IN OVEN SALES SERVICE 第 7 页共 12 页

Unfamiliar food

Power on or not?

Power on

Check if oven is hot after

working 10 mins

Time , temperature set,

tray position is nor right?

If thermostat is

on?

Turn on

thermostat

If limit stat is on?

replace

If heater resistant

is normal?

replace

Thermostatis

on?

repl

ace

Function

switch is on?

replace

Caution!

When the functions with fan have been Selected but the temperature knob is set

to zero only the fan will be on.

With this function you can cool the dish or The oven chamber.

4、Common Faults Analysis and Troubleshooting

XBKXSH140113.01 BUILT-IN OVEN SALES SERVICE 第 8 页共 12 页

5、Replacement &Cleaning the door

Attention: Before part replacement,cooker must be powered off.

Step1: Take off the door

Open the door to the maximum angle and then pull backward the movable buckle

of door hinge to the other side.

Hold the oven door and lift up (open the door 30° angle)，then slowly and obliquely

drag the door backward.

Tilt the safety catch part of the hinge upwards. Close the door lightly, lift and pull it

out towards you. In order to fit the door back on to the cooker, do the inverse. When

fitting, ensure that the notch of the hinge is correctly placed on the protrusion of the

hinge holder. After the door is fitted to the oven, the safety catch should be carefully

lowered down again. If the safety catch is not set it may cause damage to the hinge

when closing the door.

Step2: Cleaning the inside glass

XBKXSH140113.01 BUILT-IN OVEN SALES SERVICE 第 9 页共 12 页

6、Part change

Disassembly of back cover

WARNING: Turn off the electrical power supply to the appliance prior to servicing it.

Failure to disconnect the power supply during service may result in an electrical shock

or fire hazard.

Step 1: Disassemble the control panel cover and control panel back cover .

Step 2: Use a screwdriver to disassemble the screws on back cover, and take the

back cover out from the clipping hole.

Step 3: Disconnect the wires from the turbo heating element. For the sake of

reassembly convenience, please mark the connection positions before moving the

wires. Remove the screws on the turbo heating element, and then take it out of from

clipping hole.

Step 4: Use a spanner or a nut-driver to rotate the nut on the convection motor

clockwise so that the nut be taking out, and then take the fan blade and washer out of

the convection motor.

XBKXSH140113.01 BUILT-IN OVEN SALES SERVICE 第 10 页共 12 页

Step 5: Disconnect the wires on the convection motor. For the sake of reassembly

convenience, please mark the connection positions before moving the wires. Remove

the screws fixed the convection motor.

Disassembly of top, bottom heating element

Step1: Remove the door from oven (please refer to Point 6-Step 1), and put it

horizontally on the table.

Step2: Disassemble the control panel cover and control panel back cover (please

refer to Point 6-Step 2).

Step 3: Disassemble the back cover (please refer to 6-Step 3).

Step 4: Disconnect the wires on the top heating element. For the sake of

reassembly convenience, please mark the connection positions before moving the

wires. Remove the screws on the top heating element inside the cavity, and then pull

it out of the cavity ribs.

Step 5: Disconnect the wires on the bottom heating element. For the sake of

reassembly convenience, please mark the connection positions before moving the

wires. Remove the screws from the bottom heater cover，and then pull the bottom

heater assembly out from the bottom.

XBKXSH140113.01 BUILT-IN OVEN SALES SERVICE 第 11 页共 12 页

Disassembly of lamp

Step1: Open the door to the maximum angle. Remove the bulb by screwing the

lamp cover off the cavity only if the bulb is required to be replaced.

Step2: Replacement of display board

Step3: Replacement of transducer

Step4: Wire of connection box

When remove the power cable, ensure that the 3 sheet copper inside connection box

not come off。

7. Electrical schematics

XBKXSH140113.01 BUILT-IN OVEN SALES SERVICE 第 12 页共 12 页

BIL64M2-B1-11

BIL67T2-B1-11

Haier HWO60S7EX1 User manual

Brand: Haier

Model: HWO60S7EX1

Type: User manual

This manual is also suitable for

HWO60S4MX1

Download PDF

report

Haier HWO60S7EX1 User manual

This manual is also suitable for

Haier HWO60S7EX1 User manual

Related papers

Other documents