Coopers Kill Weed 8610 Operating instructions

Brand: Coopers

Model: Kill Weed 8610

Type: Operating instructions

The Kill Weed works by heating the weed foliage with an intense

heat up to 1300ºC. This destroys the internal cell structure of the

plant causing it to wither and die.

Please read these instructions carefully before use and

keep in a safe place for future reference.

SAFETY WARNINGS

• When lit, only point at the ground, never hold the burner horizontally when lit.

• Only for use on surfaces that are non-combustible such as paving, stone,

pathways etc.

• Never use near dry grass, dry leaves, straw, bark, mulch, timber, thatched roofs

or anything that could catch fire, either from direct contact or from

sparks travelling.

• Keep away from fuel tanks, flammable liquids, petrol powered lawnmowers or

power tools etc.

• Observe any local authority guides/bans on the use of naked flames in times

of drought.

• Only for use outside.

• Only use in dry, still conditions.

• Only use in a well ventilated area.

• Protective clothing and eye protection should be worn.

• Keep away from children and pets.

• Never point the Kill Weed at a person.

• Do not touch the burner head after use as this will be hot. Allow to cool fully

before storage, especially in a wooden shed.

• Follow all safety warnings on your gas can (not supplied) carefully. Keep away

from direct sunlight and extremes of temperature.

• Gas cans should be fitted or removed in well ventilated areas, preferably outside,

and away from any source of ignition such as heat, flames, cigarettes etc.

• DO NOT USE THE KILL WEED IF THE SEALING WASHER IS DAMAGED

OR MISSING.

• Do not perforate or burn the empty gas can – dispose of at your local recycling

centre.

• Do not leave unattended at any time.

• After turning off the valve to cease gas supply, be aware that the flame will stay

lit for a short time while the gas burns in the extension tube.

• Always ensure the burner is off when putting down.

• When lit, be aware that the flame may be difficult to see.

• Do not allow to get wet. Never immerse in water to cool.

• Precautions should be taken to protect any plant not to be killed.

• Protect any adjacent surface areas from heat damage.

• Do not use if any part of the Kill Weed is damaged in any way.

• Not for commercial use.

COMPONENTS

1. Adjusting valve

2. Ignition button

3. Regulating Control, on/off valve

4. Fitting for Butane Gas can (not supplied)

5. Handle

6. Tube extension

7. Burner head

5. Handle

3. Regulating control

1. Adjusting valve

4. Fitting for butane gas can

2. Piezo igniter

6. Tube extension

7. Burner head

Instructions

8610

RECOMMENDED FUEL:

Only for use with a pressurised Butane Gas can with a screw

fitting (Fig 4).

OPERATING INSTRUCTIONS

• First read the safety warnings (see overleaf).

• Check sealing washer is in place.

• Ensure the on/off valve on the regulating control (3) is closed by

turning it clockwise.

• Hold the gas can vertically and twist on anti-clockwise (Fig1).

• Ensure that a good seal is made.

• Turn the on/off valve (3) to the left to a low setting.

Immediately press the ignition button to light the burner

• Adjust the valve to increase or reduce flame intensity.

• Gently waft the flame over the weed at a distance of

approximately 15cm distance (Fig 2). Do not burn the plant

completely, only the heat is needed. Most weeds will blacken and

die in a couple of days. Stronger weeds, woody stems and those

with long deep roots may require a repeat application.

REMOVING THE GAS CAN

• Ensure the on/off valve on the regulating control (3) is closed by

turning it clockwise.

• Hold the gas can vertically and turn clockwise (Fig3).

• After turning off the valve the gas will continue to burn from the

extension tube for a short while.

• Allow to cool completely before storage.

• Store the burner and gas can separately.

GAS LEAKS

If gas can be smelt or a gas leak is suspected, turn off the valve (3)

and check the sealing washer, or fixing of the can is secure. Never

check for leaks with a naked flame. If in doubt stop use and replace

the gas can.

PACKAGING

• Dispose of the packaging at your local recycling centre.

• Dispose of paper and carton separately from plastic bags at your

local recycling centre.

• Dispose of the item at the end of its lifespan at your local

authorised household waste recycling centre.

• Dispose of gas cans at your local recycling centre.

Instructions

8610

Minimum 15cm

Screw type

Fig. 1 Fig. 2

Fig. 3

Fig. 4

Turn anti-clockwise

Turn clockwise

Coopers Kill Weed 8610 Operating instructions

Coopers Kill Weed 8610 Operating instructions

Coopers Kill Weed 8610 Operating instructions

Other documents