2. 3M
  3. Red Dot™ ECG Monitoring Electrodes, Infant, Pre-Wired, Radiolucent, 2283

3M Red Dot™ ECG Monitoring Electrodes, Infant, Pre-Wired, Radiolucent, 2283, Red Dot™ Neonatal, Pre-Wired, Radiolucent Monitoring Electrode Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the 3M Red Dot™ ECG Monitoring Electrodes, Infant, Pre-Wired, Radiolucent, 2283 Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Application Instructions
Prepare the skin.
Application sites must be clean, dry
and free of any body lotions. Cleaning
with isopropyl alcohol should be
avoided or limited to situations in
which electrode adhesion is an issue
(excessively oily or lotion covered skin).
If alcohol is used, allow it to dry prior
to electrode application.
Excessive hair at the site should be
removed by clipping.
Apply the electrodes.
Remove the electrodes from the sealed
package. Separate and straighten the
leadwires.
Remove the first electrode from the
liner.
Place the electrode on the patient and
use gentle pressure to ensure contact
of the entire electrode surface to the
skin.
Repeat for each electrode.
Connect the leadwires
to the cable yoke.
Remove a DIN plug from the
disposable holder and plug it into the
corresponding color on the cable yoke.
Repeat for each DIN plug.
3M
™
Red Dot
™
Pre-wired Monitoring Electrodes
See Removal instructions on back.
3M Health Care JOB #03R1005 TRIM SIZE =4.25” x 11”
Red Dot Appl/Remove Card COLOR: 4/C Process BLEED = +.125”
Source file in InDesign / Output file at 100% / Use fonts provided
Please recycle. Printed in U.S.A.
3M and Red Dot are trademarks of 3M.
© 3M 2010. All rights reserved.
70-2010-7553-1
3M Health Care
Infection Prevention Division
3M Center, Building 275-4E-02
St. Paul, MN 55144-1000
USA
1-800-228-3957
www.3M.com/infectionprevention
Removal Instructions
Loosen one side of the electrode.
Grasping the full width of the electrode,
slowly and gently pull it back over itself.
Electrodes should be removed in the
direction of hair growth whenever
possible. Keep the electrode close to
the skin surface as you pull it back, and
support the skin immediately adjacent
to the adhesive being removed.
To remove the DIN plug from the cable
yoke, grasp the plug firmly and pull.
Repeat for each DIN plug.
DO NOT remove the DIN plugs from
the cable by pulling on the wires.
All 3M Red Dot Monitoring Electrodes
are backed with a guarantee that’s
“Good as Gold.” If, for any reason,
you are dissatisfied with 3M Red Dot
Monitoring Electrodes, we will replace
the unexpired/unused product or, if
you prefer, refund the purchase price.
To learn more about 3M Red Dot Electrodes, call the 3M Health Care
Helpline at 1-800-228-3957 or visit www.3M.com/reddotelectrodes.
3M
™
Red Dot
™
Pre-wired Monitoring Electrodes
/