INSTALLATION INSTRUCTIONS FOR
SIDE PANEL AND BI-FOLD GLASS DOORS
107541-01
Rev. A
05/00
For more information, visit www.desatech.com
2701 Industrial Drive
P.O. Box 90004
Bowling Green, KY 42102-9004
www.desatech.com
INTERNATIONAL
NOT A UPC
107541 01
Figure 1 - Mounting Hole Locations for
Side Panel and Bi-Fold Doors
Figure 2 - Installing Side Panel and Bi-
Fold Doors
1. To install the glass panel, insert the two
pins, located on the top of the glass
panel frame, into the top door track.
2. Push the glass panel as far up as pos-
sible so that the two pins located on the
bottom of the glass panel will fit into
the two pivot plate holes located on the
bottom of the fireplace opening. Adjust
the glass panel until it is fully seated.
Refer to Figures 1 and 2.
3. Identify the left and right doors. If the
door has pins on the top, one pin on the
bottom, and the handle is located on the
lower right side, it is the left side door.
4. For the left side door, insert the far left
pin into the top left spring clip hole. At
the same time, make sure the other top
pin is in the top door track.
5. Push the glass door up as far as pos-
sible so the bottom pin can be placed
into the pivot plate hole. Adjust the
glass door until it is fully seated . Re-
fer to Figure 2.
6. Repeat steps 4 and 5 for right side door.
Holes for the
Glass Panel
Holes for the
Left Door
Top Slot Under Frame
Adjustment Clip
Short Pivot Pin
Bottom Pin
Bottom Slot
Adjustment Clip
-
1
