Facom V.96F Owner's manual

Page is loading ...

WARNING

IMPORTANT SAFETY INFORMATION ENCLOSED.

READ THIS MANUAL BEFORE OPERATING TOOL.

IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PLACE THE INFORMATION IN THIS MANUAL INTO THE HANDS OF THE OPERATOR.

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.

EN

PLACING TOOL IN SERVICE

• Always operate, inspect and maintain this tool in accordance

with all regulations (local, state, federal and country), that may

apply to hand held/hand operated pneumatic tools.

• For safety, top performance, and maximum durability of parts,

operate this tool at 90 psig (6.2 bar/620 kPa) maximum air

pressure at the inlet with 3/8” (10 mm) inside diameter air

supply hose.

• Always turn off the air supply and disconnect the air supply

hose before installing, removing or adjusting any accessory on

this tool, or before performing any maintenance on this tool.

• Do not use damaged, frayed or deteriorated air hoses and

ttings.

• Be sure all hoses and ttings are the correct size and are tightly

secured.

• Always use clean, dry air at 90 psig maximum air pressure.

Dust, corrosive fumes and/or excessive moisture can ruin the

motor of an air tool.

• Do not lubricate tools with ammable or volatile liquids such as

kerosene, diesel or jet fuel.

• Do not remove any labels. Replace any damaged label.

• The use of a hose whip is recommended. A coupler connected

directly to the air inlet increases tool bulk and decreases tool

maneuverability.

• For maximum performance, the coupler on the wall should be

the next size larger than the coupler used on the tool. The coupler

closest to the tool should not be less than the proper air supply

hose size.

NOTICE

The use of other than genuine FACOM replacement parts may result in safety hazards, decreased tool performance, and increased

maintenance, and may invalidate all warranties.

Repairs should be made only by authorized trained personnel. Consult your nearest FACOM Authorized Servicenter.

USING THE TOOL

• Always wear eye protection when operating or performing

maintenance on this tool.

• Always wear hearing protection when operating this tool.

• Keep hands, loose clothing and long hair away from rotating

end of tool.

• Anticipate and be alert for sudden changes in motion during

start up and operation of any power tool.

• Keep body stance balanced and rm. Do not overreach when

operating this tool. High reaction torques can occur at or below

the recommended air pressure.

• Air powered tools can vibrate in use. Vibration, repetitive mo-

tions or uncomfortable positions may be harmful to your hands

and arms. Stop using any tool if discomfort, tingling feeling or

pain occurs. Seek medical advice before resuming use.

• Use accessories recommended by FACOM.

• This tool is not designed for working in explosive atmospheres.

• This tool is not insulated against electric shock.

WARNING

WARNING LABEL IDENTIFICATION

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.

WARNING

Always wear eye protection when operating or

performing maintenance on this tool.

WARNING

Always wear hearing protection when operating

this tool.

WARNING

Air powered tools can vibrate in use. Vibration,

repetitive motions or uncomfortable positions may be

harmful to your hands and arms. Stop using any tool if

discomfort, tingling feeling or pain occurs.

Seek medical advice before resuming use.

WARNING

Do not carry the tool by the hose.

WARNING

Keep body stance balanced and rm. Do not overreach

when operating this tool.

WARNING

Always turn off the air supply and disconnect the air

supply hose before installing, removing or adjusting

any accessory on this tool, or before performing any

maintenance on this tool.

WARNING

Operate at 90 psig (6.2 bar/ 620 kPa) Maximum air

pressure.

WARNING

Do not use damaged, frayed or deteriorated air hoses

and ttings.

LUBRICATION

FACOM NS.557

Always use of an air line lubricator with these tools. We recommended the

following Filter-Lubricator-Regulator Unit: FACOM N.553D.

After each eight hours operation, unless the air line lubricator is used, detach

the air hose and inject about 1-1/2 cc of oil into the inlet busching.

After each forty-eight hours of operation, or as experience indicates, remove

the Oil Chamber Plug and ll the mechanism oil chamber with the recommen-

ded oil FACOM NS.557.

PLACING TOOL IN SERVICE

Page is loading ...

En France, pour tous renseignements techniques sur l'outillage à main, téléphonez au : 01 64 54 45 14

BELGIQUE

LUXEMBOURG

FACOM Belgique S.A/NV

Weihoek 4

1930 Zaventem

BELGIQUE

�

: (02) 714 09 00

Fax : (02) 721 24 11

NEDERLAND

FACOM Gereedschappen BV

Kamerlingh Onnesweg 2

Postbus 134

4130 EC Vianen

NEDERLAND

�

: (0347) 362 362

Fax : (0347) 376 020

DANMARK

FINLAND

ISLAND

NORGE

SVERIGE

FACOM NORDEN

Nordre Strandvej 119B

3150 HELLEBÆK

DENMARK

�

: (45) 22 17 08 00

Fax : (45)

SINGAPORE

FAR EAST

FACOM TOOLS FAR EAST

N° 25 Senoko South Road

Woodlands East Industrial Estate

Singapore 758081

SINGAPORE

�

: (65) 6752 2001

Fax : (65) 6752 2697

DEUTSCHLAND

FACOM GmbH

Otto-Hahn-Straße 9

42369 Wuppertal

DEUTSCHLAND

�

: +49 202 69 819-329

Fax : +49 202 69 819-350

SUISSE

ÖSTERREICH

MAGYARORSZAG

CESKA REP.

FACOM OUTILLAGE SARL

Ringstrasse 14

8600 DÜBENDORF

SUISSE

�

: 41 44 802 8093

Fax : 41 44 802 8091

ESPAÑA

PORTUGAL

FACOM Herramientas SRL

Poligono industrial de Vallecas

C/Luis 1°, s/n-Nave 95 - 2°Pl.

28031 Madrid

ESPAÑA

�

: (91) 778 21 13

Fax : (91) 380 65 33

UNITED

KINGDOM

EIRE

FACOM-UK

Europa view

SHEFFIELD BUSINESS PARK

UNITED KINGDOM

�

: (44) 114 244 8883

Fax : (44) 114 273 9038

ITALIA

Utensilerie Associate srl.

Via Volta 3

21020 Monvalle (VA)

ITALIA

�

: (0332) 790 381

Fax : (0332) 790 307

POLSKA

FACOM Tools Polska Sp. zo.o.

ul.Modlińska 190

03-119 Warszawa

POLSKA

�

: (00 48 22) 510 36 55

Fax : (00 48 22) 510 36 56

FRANCE

&

INTERNATIONAL

Société FACOM

6-8, rue Gustave Eiffel B.P.99

91423 Morangis cedex

FRANCE

�

: 01 64 54 45 45

Fax : 01 69 09 60 93

http:/ /www.facom.fr

Europa link

SHEFFIELD

Facom V.96F Owner's manual

Facom V.96F Owner's manual

in other languages

Related papers

Other documents