Page 1

17 - REMOTE CONTROL OPERATION INSTRUCTIONS

B. REMOTE CONTROL INFORMATION

Figure 17A

Thermostat Mode

Battery Life

Set Temperature

(visible only in

Thermostat Mode)

Flame Height

Pilot

Left To Right:

Flame, Light, Fan and Set

Up

Mode

Down

A. REMOTE ICON IDENTIFICATION

A double receptacle box cover and (3) wire nuts are supplied in replace components packet to be used when hardwiring to electrical box

located under rebox on right side of replace.

IMPORTANT ELECTRICAL WARNING AND INFORMATION

THIS SYSTEM GOES THROUGH A CALIBRATION MODE WHEN SWITCHING FROM ‘ON’ TO ‘THERMO’ TO ‘OFF’ MODES, CREATING A

HUMMING SOUND WHICH IS A NORMAL PART OF OPERATION.

Page 2

C. CONTINOUS PILOT - FOR VERY COLD CONDITIONS

The IPI gas control system has the option of a continuous (standing) pilot feature. This allows you to change from a spark-to-pilot system to a stand-

ingpilotsystemduringcoldweatherconditions.Byhavingthepilotoncontinuously,thereboxwillremainwarmandadraftisestablishedinthevent,

allowingthemainburnertoturnonwithlessair-owdisruption.

Beforematchingsecuritycodesmakesure120VACisconnectedandpoweredtoreplace,andhandheldremotecontrolisinstalledwith(2)

batteries.ItmaybenecessarytoprogrammaincontrolmoduletoLEARNthesecuritycodeofthehandheldremotecontroluponinitialuse,if

batteriesarereplaced,orifareplacementremotecontrolispurchasedfromyourdealer.

1. Whenmatchingsecuritycodes,besureslidebuttononmain

controlmoduleisinREMOTE;thecodewillnot“LEARN”ifslide

isinOFF.

2. ProgrammaincontrolmoduletoLEARNanewsecuritycodeby

pushinginLEARNbuttononmaincontrolmoduleusingapencil

pointfor2secondsandletgo(youshouldhearaseriesof‘beeps’

letting you know module is ready to learn a new code).

overwrite the old one.

Ifiteverbecomesnecessarytoclearthememoryfromthehandheld

remotecontrol,simplypushandholdtheLEARNbuttonfor10seconds

(youshouldhearthreelongbeepsinsuccession).Youmaynowfollow

stepsoutlinedaboveto‘RE-LEARN’securitycodes.

Figure 17E

IMPORTANT NOTE

When operating replace in this capacity, the only function available is ame modulation.

1. Thisreplacehasanoptionalbatteryoperationifelectricalpowerislost(seePage45,Figure16B).Positionbatterypackwithfour“AA”size

No ame adjustments are available nor will the remote control be available for the fan, ember lights, thermostat, etc.

CONNECTION

REMOTE

ON/OFF SWITCH

CONTINUOUS

PILOT SWITCH

120 VAC

ADAPTER

CONNECTION

WIRE HARNESS CONNECTION

▲

▲

▲

Page 3

F. INTITAL SET-UP

Plug Extension Module and AC Adaptor into receptacles.

Install(4)AAbatteriesintobatterycompartmentofBackup Battery Pack,makingsurebatteriesareinstalledinproperdirection.Positionbetween

• If converting from NAT to LP gas: (1) one second long beep

• If converting from LP to Nat gas: (3) three second long beep

Continuewithgastypeconversionbyfollowinginstructionsincludedwithgasconversionkit.

H. CELSIUS/FAHRENHEIT CONVERSION

PressUPandDOWNkeyssimultaneouslytochooseCelsiusorFahrenheit.

I. IMPORTANT SAFETY FEATURE

J. CONTINUOUS PILOT FEATURE

K. CHILDPROOF FEATURE

Thissystemhasamaximumroomtemperaturelimitof95°F(35°C)inbothmanualandthermostatmodes.Whenroomtemperatureisatorabove

this point the system will shut down and the hand held remote control will read OFF. If you turn the system ON when room temperature is still at or

ActivationofthisoptionalfeatureisaccomplishedbypushingSET &

UPbuttonssimultaneouslyfor5seconds.Thechildproof icon will

appearonthescreen.Whenatransmitterbuttonispressedtheicon

willashonscreen,butnosignalwillbetransmitted.Pressingand

holdingthesesametwobuttonsagainformorethan5secondswill

de-activate this function.

This feature controls only manual functions of the hand held remote,

automaticfunctions(thermostatmode)willnotbeaffected

.

Figure 17J

Page4

17 - REMOTE RECEIVER INFORMATION

L. MANUAL MODE

Press MODEbuttonformanualON.Theameiconwillappearon

the LCD screen. Press MODEbuttonagaintoputthecontrolinto

THERMO mode. Pressing MODEagainwillturnreplaceOFF.

Thisremotewilloperatethefan,allowingfor(6)differentspeedlevels.

When the FANbuttonispressed,FAN levelsettingwillashonthe

LCD screen. Press UP or DOWNbuttonstoselectdesiredfanspeed

level.Ifnoadjustmentismadewithin7seconds,thecontrolwillexit

function setting mode and LCD display will return to normal view.

Thisremotewilloperatethelights,allowingfor(6)differentlightlevels.

When LIGHTbuttonispressed,LIGHTlevelsettingwillashonthe

Page5