2. Balboa Water Group
  3. Replacing HydroAir Main Drain Cover

Balboa Water Group Replacing HydroAir Main Drain Cover User manual

  • I have reviewed the instructions for replacing the Hydro Air Main Drain Cover, part number 10-6200. This document provides a step-by-step guide for the replacement process, including necessary tools and safety precautions. I'm ready to answer any questions you may have about installing your new drain cover.
  • What tool is required for the replacement?
    What should I do before starting the replacement process?
    What should I do after replacing the Main Drain Cover?
INSTRUCTIONS FOR REPLACING HYDRO AIR
MAIN DRAIN COVER
for Assembly Part Number 10-6200
Tools required: Phillips Screwdriver
1. TURN OFF ALL POWER TO THE SPA / HOT TUB / SWIMMING POOL.
NOTE: IF NECESSARY, SHUT OFF THE CIRCUIT BREAKER FOR THE SPA.
2. Remove the four screws holding the old Main Drain Cover in place.
3. Remove the cover from the Main Drain Assembly by lifting the cover away from the
assembly in the same direction you removed the screws.
4. Place the Replacement Cover on the fitting from which you just removed the old cover.
Be sure the screw holes in the cover line up with the threaded holes in the fitting.
5. Install the four new screws which came with the Replacement cover, using the Phillips
screw driver. Tighten screws until snug.
Replacement is complete. Be sure cover is secured in place before restarting spa.
REPLACEMENT
MAIN DRAIN
COVER
OLD MAIN DRAIN
COVER
88-6200 Rev B June 16, 2009
/