2. Hay
  3. Beam

Hay Beam User manual

  • I've reviewed the Assembly Instruction for the HAY Beam 60 CM and 90 CM. This document provides step-by-step instructions for mounting the beam, including drilling, using rawlplugs, and attaching hooks. I'm ready to answer any questions you have about the assembly process.
  • What size drill bit is required for the holes?
    What is the distance between the two mounting points for the 60 CM beam?
    What is the distance between the two mounting points for the 90 CM beam?
2
1
3
4
5
ASSEMBLY INSTRUCTION
BEAM 60 CM
A x 1
B x 4
C x 2
D x 2
E x 2
F x 1
Mark two points, distance 46 cm
Drill two holes, Ø7 mm
Move the beam (A) left, to interlock
Correct interlocked position
Place the beam (A) on the screws
Tighten the screws (C) with key (F)
Slide hooks (B) onto the beam (A)
46 cm
C E D
C
A
A
F
10mm
Place rawlplugs (D) in the holes,
then washers (E) and screws (C)
Move the beam (A) left, to interlock
Correct interlocked position
Place the beam (A) on the screws
Tighten the screws (C) with key (F)
Slide hooks (B) onto the beam (A)
2
3
4
5
ASSEMBLY INSTRUCTION
BEAM 90 CM
A x 1
B x 5
C x 2
D x 2
E x 2
1
76 cm
C
A
A
F x 1
F
10mm
C E D
Place rawlplugs (D) in the holes,
then washers (E) and screws (C)
Mark two points, distance 76 cm
Drill two holes, Ø7 mm
/