COMPACT
DIGITAL AUDIO
RCA LINE OUT
R
C
A
L
I
N
E
O
U
T
HIGH POWER
4 X 35 Watts
Max.
HIGH POWER
4 X 35 Watts
Max.
HIGH POWER
4 X 35 Watts
Max.
AM/FM/MPX WITH
SINGLE CD PLAYER
DIRECT-IN PLAY POWER LOADING
TOP/REPEAT/RANDOM/SCAN
3-BEAMLASER TRACKING SYSTEM
DUAL 1-BIT D/A CONVERTERS
24AM/FMPRESETSTATIONS
SEEK UP/DOWN
PRESET SCAN AND AUTO SEARCH
SEA9526
Marine Audio System
OWNER S MANUAL
,
VOL-
VOL+
BND/LD
AS/PS
SCAN
CLK MONO OPEN
56
3RPT 4RDM
MODE 1PAU 2INT
DSP
MUT
PWR
PUSH/SEL
CD PLAYER
Signal / Noise Ratio ...........................................
Frequency Response ................................
Channel Separation .............................................
D / A Converter ...................................................
>65dB
20 Hz~20KHz
>62dB
16 Bit
GENERAL
Operating Power ..............
Output Wiring.........
RCA line out........................
Output Impedance .......................
Fuses .........................................................................
Dimensions ..................................
Weight .........................................................................................
Compatible 4 to 8 Ohm Speakers
1 amp and 10 amp
178mm(W) x 146mm(D) x 51mm (H)
2.6 Kg
Designed for using four speakers only
Front and Rear Channels
RCA low-level outputs - 500 mV.
FM Tuner
Tuning Range .............................................
FM Mono Sensitivity ...........................................
50 dB quieting sensitivity ...................................
Stereo Separation @ 1 Khz .................................
87.5-107.9 Mhz
12 dB
16 dB
30 dB
AM Tuner
Tuning Range ..........................................
AM Sensitivity ......................................................
530-1710 Khz
30 dB
AMPLIFIER
Output Power ............................
T. H. D. ................................................................... 0.5 %...........................
Bass ..................................................................... +/ dB....................... - 12
Treble ................................................................... +/ - 12dB.........................
140 WATTS MAXIMUM
35 WattsX4 Channels
10
1
Contents...................................................................... .. ............1..... ......
Installation.............................. ......... ......... .......... ..................2........ .. ..... .
Installation and removing the unit...................... .... .........................3......... .
Using the Detachable Front Panel........................ .. ...............4... ...................
Wiring Diagram................... .......................................... .5..... .....................
Basic Functions ............................. ............................ 6........ ......................
Basic Operation........ .................................................................... 7... .......
Radio Operation..................................................................... ....... 8... .......
CD Player Operation............. .......................................................... 9... ......
Specifications................ .............................................. 10.... ......................
12 Volts DC, Negative Ground
CONTENTS SPECIFICATIONS
BND/LD
AS/PS
SCAN
RADIO BAND
Press the BD/LD button to operate the radio function.
Thereare3setstotalforFMband(FM1,FM2,FM3)
Thereis1setAMband(MW)
Up to 6 preset stations can be stored for each set.
TUNE/SEEK
1. In radio mode, press the BD/LD button to choose band. Every
time this button is pressed, the new band shows on the display.
2.PresstheUPorDNbuttontomovetheradiofrequencyupor
down.Pressanypresetbuttonfor2secondstostorethedesired
station.
3. Repeat above steps to seek and store other stations.
4. Press the AS/PS button for 2 seconds until the unit starts to
automatically seek strong stations and stores them in memory.
5. At radio mode, press the SCAN button to scan through all
strong stations 5 seconds on each one.
Duringthis5secondspressthebuttonagain,tostopona
desired station.
6.InFMRadio,pressMON(Mono/St)buttontoselectstereoor
mono reception. Only stereo is shown on the Display.
SELECTING A PRESET
Press preset button 1-6 to listen to a stored station of
your choosing.
F1 F2 F3
MW
8
3
1. Dashboard
2. Nut(5mm)
3. Spring washer
4. Sc rew(5X25mm)
5. Screw
6. Strap
Besuretousethestraptosecurethe
backoftheunitinplace.Thestrapcan
be bent by hand to the desired angle.
7. Plain washer 1. Before removing the unit, press the
OPEN button to slide down the front
panel.
2. Lever
lnsert the levers supplied with the unit
into the grooves in the housing (as
showninfigure)untiltheyclick.Pull
theleverstoremovetheunitfrom
the dashboard.
Removing the unit
Front Panel
OPEN button
INSTALLATION AND REMOVING THE UNIT
1
(Fig.2)
1
2
3
4
5
6
7
2
BND/LD
AS/PS
SCAN
CLK MONO
56
3RPT 4RDM
MODE 1PAU 2INT
DSP
BND/LD
AS/PS
SCAN
CLK MONO
56
3RPT 4RDM
MODE 1PAU 2INT
DSP
RADIO OPERATION
CLOCK SETTING/DISPLAY
1. To display the current time, press the
displaywillreturntonormalstatus afterfiveseconds.
2. To adjust the time,
.
CLK button once. The
press the CLK button to display the
current time. Press and hold the button again while using the
up or down buttons to adjust the minute and hour.
POWER ON/OFF
Press the power button to
turn the unit on. Press it
againtoturnitoff.
BASS
1. Press SEL button once,
to display BASS.
2.ToadjustBASSlevel,
turn knob left or right.
TREBLE
1. Press SEL button twice,
to display TRE
2.To adjust TRE level, turn
knob left or right.
BALANCE
1. Press select button three
times, to display BAL
2. To adjust BAL level, turn
knob left or right.
FADER
1. Press select button four
times, to display FAD
2. To adjust FAD level, turn
knob left or right.
MUTE
PresstheMUTEbuttontokeeptheunitinsilentmode.Press
MUTE again. To resume normal listening.
VOLUME
To adjust volume level,
turn knob left or right.
DSP
Press this function button to choose between CLASSIC, ROCK or POP.
7
1. Press the OPEN button,
thefrontpanelwillslidedown.
1.Whenthepanelbracketisinslidedown
position, insert the front panel into the
panelbracket,thenpushthefrontpanel
from the middle to slide it up.
2.Whenthepanelbracketisinslideup
position, insert one side of the front panel
toitsproperpositionandpushtheother
side into the panel bracket. A 'click'
sound should be heard.
2. When the front panel slides down, press
thebottombuttonofthefrontpanel
upward and pull out from the panel
bracket.
3. Note that if the front panel fails to lock
in position properly, the control button
may not function and LCD display may
be missing some segments.
To eliminate this problem press the
open button and then re-install the
front panel again.
3. For safekeeping, store the front panel in
the supplied protective case immediately
after being remoed.
To Detach the Front Panel: ToReinstalltheFrontPanel:
4
Open
Bottom
button
Bottom
button
Front panel
Protective Case
Front panel
PWR
PUSH/SEL
PUSH/SEL
CLK MONO
56
3RPT 4RDM
MODE 1PAU 2INT
DSP
BND/LD
AS/PS
SCAN
CLK MONO
56
3RPT 4RDM
MODE 1PAU 2INT
DSP
MUT
BASIC OPERATION USING THE DETACHABLE FRONT PANEL
Follow this easy wiring diagram to install new or existing Radio and Speaker Wiring System.
Warning:
This unit is designed for use with 4 speakers; however, it can be installed using only 2 speakers.
If installing 2 speakers, do not connect front and rear speaker leads together. Use either the
front or rear leads insulating the unused wires. Never ground negative speaker leads to the
chasis ground of the boat.
OUTPUT LINE PLUG
1. POWER ON/OFF
2. BD/LD (FM1-FM2-FM3-MW)
3. SEEK & STORE AUTOMATICALLY
4. SOUND EFFECT SELECT BUTTON
5. MUTE BUTTON
6. CLOCK BUTTON
7. CD /RADIO MODE SELECT
8. AUDIO CONTROL ENCODER SWITCH
9.AUDIOCONTROLMODESELECTBUTTON
10.
11. SEEK/SELECT TRACK/FAST REVERSE
12. RESET BUTTON
SEEK/SELECT TRACK/FAST FORWARD
65
Power
Antenna
Blue
Back-up
Ground(B-) Black
Yellow
Memory
4-Speaker System
Front
Lch.SPK
Rear
Lch.SPK
White
White/Black
Green
Green/Black
RCA Connector
4-Speaker System
Front
Rch.SPK
Rear
Rch.SPK
Grey
Grey/Black
Violet
Violet/Black
Red
Ignition
Switch(B+)
10A FUSE
CDC Connector
REMOTE
18914 11 13
10
2
54
720 21 18 19 16 17 6
VOL-
VOL+
BND/LD
AS/PS
SCAN
CLK MONO OPEN
56
3RPT 4RDM
MODE 1PAU 2INT
DSP
MUT
PWR
PUSH/SEL
22 24
23
3
AUX Connector Connector
15 12
13. EJECT
14.FUNCTIONLCDDISPLAY
15. DISC SLOT
16. PRESET STATION 5
17.PRESETSTATION6
18.REPEATPLAY/PRESETSTATION3
19. RANDOM PLAY/ PRESET STATION 4
20. PAUSE/PRESET STATION 1
21. TRACK SCAN/ PRESET STATION 2
22. MONO/STEREO SELECT BUTTON
23. STATION SCAN UP BUTTON
24.PANELRELEASEBUTTON
FUNCTIONS
WIRING DIAGRAM
/
