Rev. D
INST-635
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
7110-1008
MONGOOSE CLEVIS
7160-0498
STEEL BACKUP PLATE
STEEL BACKUP PLATE
(INST-521)
KEYBOARD TRAY
(INST-614)
NYLON BEARING
4X .25 FLAT WASHER
NYLON BEARING
4X .25-20 NYLOK NUT
2X .25-20 x 1.00 HEX HEAD BOLT
7160-0427
9" LOCKING SLIDE ARM
REMOVE HOLE PLUG
7160-0494
TABLET
DISPLAY MOUNT
(INST-606)
or
7160-0529
TALL TABLET
DISPLAY MOUNT
(INST-606)
KIT - TABLET DISPLAY MOUNT,
Printing Spec:
7170-0218-01
INSTALLATION INSTRUCTIONS
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
7170-0218
Revision
PS-001
Product Form
9" LOCKING SLIDE ARM, KEYBOARD TRAY
KIT - TALL TABLET DISPLAY MOUNT,
9" LOCKING SLIDE ARM, KEYBOARD TRAY
Assemble 7170-0218 and 7170-0218-01 Kit components as shown below.
Refer to the instruction sheet supplied with each component for details specific
to the component.
© Copyright 2014 Gamber-Johnson, LLC
/
