tbirdusa.com
tel: (619) 448-3567
Data is subject to manufacturing tolerances.
fax: (619) 448-9072
1895 Gillespie Way, El Cajon, CA 92020
LINEAR DRAIN INSTALLATION
height adjuster
subfloor
and grate or tile tray
hardware
drain flange
mortar
clamping ring
thinset / mortar
waterproofing
drain body
Thunderbird Products linear channel
tile (sloped)
Step 1: Set drain into pre-cut or formed opening
and attach coupling to drain pipe.
Step 2: Nail or mechanically attach drain flange to floor.
Step 3: Apply waterproofing over floor and drain flange.
Step 4: Mechanically attach clamping ring to drain
with supplied hardware.
Step 5: Hand thread plastic height adjuster into drain opening.
Step 6: Place linear drain outlet into plastic adjuster and hand
thread adjuster to your desired finished height.
Step 7: Apply mortar under and around linear channel.
Use caution to avoid mortar entering weep holes.
Make sure there is enough room to allow tile to finish
flush with top of linear grate.
Step 8: Install tile to finished height. Make sure it is sloped
toward linear channel.
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Luxe TI-26 Installation guide
-
Neodrain Square Shower Drain Installation guide
-
Neodrain 24-Inch Linear Shower Drain Installation guide
-
Schluter KL1BL19EB110 User manual
-
Schluter KK122ABSECS Installation guide
-
Unbranded KKB81152PVCE Installation guide
-
Schluter ST-81/152 Installation guide
-
-
-
Schluter Systems KERECK135FI10 User manual
