1/8 PIPE NIPPLE
BACK PLATE
MOUNTING LUG
1/8 HEX NUT
BACK PLATE
MOUNTING SCREW
Step 1:
The backplates have 3 mounting lugs attached to them with the use of a short 1/8 Pipe
Nipple (hollow in center) .
Installing Mounting Lug to Backplate
Mounting of Screws
Screws are inserted through the mounting lug so that it protrudes through other side
of backplate.
Step 2:
HTL-Tower Shelf
INSTALLATION INSTRUCTIONS
No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.
BACK PLATE
MOUNTING LUG
MOUNTING SCREW
WING NUT (INSTALLED)
WING NUT INITIAL POSITION
-SQUEEZED OFF TO FIT DRILLED HOLE
IN WALL
SECTION VIEW OF THE INSTALLATION
WALL
Large Arm
Medium Arm
Small Arm
Set Screw
Step 3:
Wing nut is attached to screw and pushed into wall.
Wing Nut Installation
Arms Installation
Backplates are tightened against wall and then three arms are attached to mounting lug
with use of set screw.
Step 4:
WALL
No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.
-
1
-
2
Allied Brass HTL-3-BKM Installation guide
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI