11
Before using for the fi rst time
Remove any packaging materials and check
that all components are present.
Before the appliance is used for the fi rst
time, or after extended periods of non-use, it
should be thoroughly cleaned as described
in the section Cleaning and care.
Operation
We recommend the use of long-life low-fat
milk (UTF, 1.5% fat content). For best
results, the milk should be taken from the
refrigerator immediately before frothing.
The underside of the container and the contact
area on the inside of the base must be clean
and dry.
Choosing the stirring head
∙ Use the smooth stirring head to heat up
milk.
∙ For frothing and heating milk at the same
time, use the serrated head.
∙ For cold-frothing milk, also use the
serrated head.
∙ During periods of non-use, the stirring
heads may be safely stored at the rear of
the housing.
Fill amounts
∙ Always observe the minimum mark and
ensure the container is fi lled with at least
120 ml milk.
∙ For frothing, fi ll the container to a
maximum of 260 ml (lower max mark
).
∙ For heating, fi ll the container to a
maximum of 560 ml (upper max mark
).
Heating up or hot-frothing milk
1. Place the container onto the base.
2. Remove the lid from the milk container.
3. Place the appropriate head onto the
mounting protrusion inside the bottom
of the container.
4. Put the required amount of milk into the
container.
5. Place the lid on the container.
6. Insert the plug into a suitable wall
socket. A beep-signal is heard and the
main indicator lamp fl ashes.
7. Press the On/Off switch.
8. A double beep-signal is heard, the main
indicator lamp shows a steady light
and the motor cooling system of the
appliance is heard to start up.
A moment later, the appliance starts
to heat up and stir the milk. Once the
milk is suffi ciently hot, the heating and
stirring process stops automatically.
The main indicator lamp starts fl ashing
and a number of beep-signals are
heard.
9. You can now remove the milk container
from the base. Use a suitable spoon to
take off the milk froth.
The cooling system continues to run
for a brief period. The main indicator
lamp stops fl ashing after about 3
minutes. The power cord can now be
disconnected from the socket.
Remarks
If the appliance has not been disconnected
from the mains , the On/Off switch must be
pressed twice to start a new operating cycle.
After a heating-up cycle, the appliance
cannot start a new stirring and heating
cycle immediately, but must be allowed to
cool down fi rst.