13
en
6 Standby button a
Button a switches on the appliance or
switches it to stand-by mode. When button
a is pressed, the appliance heats up and
buttonaasheswhiletheapplianceheats
up and is rinsed. When the buttons 4, 5, a
and h light up and one, two or three beans
(depending on the setting) appear on the
display, the appliance is ready for operation.
The appliance will not be rinsed if:
– it was still warm when switched on, or
– coffee was not discharged before it was
switched to “stand-by“ mode,
or
– steam was discharged shortly before it
was switched off.
7 Steam generation button h
Button h generates steam for foaming or
warming.
8 Steam dispensing dial
Hot water or steam can be dispensed by
turning the dial to hot water g or steam h.
To dispense steam, the steam generation
button hmustbepressedrst(see“Steam
for foaming milk“).
Settings and displays
Setting the water hardness
It is important that the water hardness be
set correctly, so that the appliance indicates
accurately when the descaling programme
should be run. The factory setting is a water
hardness of 4. You can check the water
hardness using the enclosed test strip or by
asking your local water supplier.
Degree Water hardness
German (°dH) French (°fH)
1
2
3
4
1-7
8-15
16-23
24-30
1-13
14-27
28-42
43-54
●Determinethewaterhardnesswiththe
enclosed test strip.
e.g. = Hardness 2
●Switchthedevicetostandby.
●Holddownthesteambuttonh for at
least 3 seconds. The number of service
buttons 4, 5, a, h that light up indicate
the selected water hardness.
●Pressthesteambuttonh repeatedly
until the correct number of buttons is lit.
●Pressbuttona once. The selected
number of service buttons should light
upbriey;thisindicatesthatthedesired
water hardness setting has been saved
successfully.
Ifawaterlter(specialaccessory)isused,
the water hardness should be set to 1.
Note: If no button is pressed within 90
seconds, the appliance switches to stand-
by mode without saving the new settings.
In this case, the previous water hardness
setting is retained.
Thersttimealterisusedorafter
changingthelter,theapplianceneedsto
be cleaned.
●Fillthewatertankuptothe0.5lmark.
●Placeasuitablecontainer(approx.0.5
litres) under the nozzle 9.
●Turnthedial8 to g/h.
●Ifnowatercomesoutofnozzle9, turn
the dial back to O.
●Fillthewatertankandwaterpipes(see
section “Switching on the appliance”).
Adjusting the grinding unit
Sliding switch 16 adjusts the degree of
grinding,fromcoarsetone.
Warning
Adjust the grinding unit only while it is
running! Otherwise the appliance may be
damaged.
●Pressthecoffeedispensingbutton4.