See Use & Care Manual for “Match Lighting Instructions” and to
perform the Burner Flame Check” and important safety
instructions before using.
Back of Grill
Leg wires on Warming Rack
must run underneath surface.
A
B
Items to Assemble:
1 Vaporiser Bar
1 Grate
Push Vaporiser Bar
down onto rest in
Grill Bottom
Items to Assemble:
2 Shelves
8 Crown Nuts
8 Carriage Bolts
Qty: 8
Qty: 8
463735703
Correct position of LP tank
and tank wire support
bracket after grill assembly
Hinge Pin
and Hitch Pin
Qty: 2
Qty: 2
Qty:2
Items to Assemble:
1 Grill Lid
2 Hinge Pins
2 Hitch Pins
1 Handle
2 Wing Nuts
1 Logo Plate
Note: Grill lid
style may vary.
10
Items to Assemble:
1 Warming Rack
1 Cooking Grate
A
B
Insert pivot wire of Warming
Rack into Lid. Flex leg
wires to insert into Grill
bottom.
Place cooking grate
into grill bottom.
Hang grease clip from center of grill bottom.
Use an empty soup can (not included) to hang
from grease clip.
Items to Assemble:
1 Grease Clip
1 Tank Wire Support Bracket
1 LP Tank
LP tank is shipped empty. Fill and leak check before
attaching to grill and regulator.
CAUTION
!
• Failure to install can in clip will cause hot grease
to drip from bottom of grill with risk of fire or
property damage.
• Tank collar opening must face to front of cart
once tank is attached.
• Failure to install tank correctly may allow gas
hose to be damaged in operation, resulting in
the risk of fire.
Item to Assemble:
1 Wire Shelf
1 Panel
2 Push Pins
Qty: 2
placing tabs into slots on Bottom Shelf.
Attach with push pins.
A
B
Assemble front panel first by
Place Wire Shelf in 3rd hole from top.
A
B
Items to Assemble:
1 Condiment Basket
Items to Assemble:
1 Grill Bottom
1 Heat Shield
2 Carriage Bolts
2 Wing Nuts
Qty. 2
Qty.2
Qty: 2
Items to Assemble:
2 Wheel Assemblies
2 Hitch Pins
2 Leg Extenders
Items to Assemble:
2 Leg Assemblies
1 Bottom Shelf
6 carriage Bolts
6 Wing Nuts
Qty: 6
Qty: 6
Place Bottom Shelf and Legs as shown.
After assembling tighten all Wing Nuts.
Right Side:
Attach 2 Carriage Bolts and Wing Nuts in
front and back.
Left Side:
Place 1 Carriage Bolt
and Wing Nut in upper hole only
Attach Wheels with Hitch Pins
6
5
4
9
3
8
2
7
1
Grease Clip
/