Diver Down Front and Rear Neoprene Seat Covers Installation guide

Brand: Diver Down

Model: Front and Rear Neoprene Seat Covers

Type: Installation guide

Diver Down Front and Rear Neoprene Seat Covers enhance the style, protection, and comfort of your Jeep Wrangler JL or Gladiator JT. Custom-designed for a precise fit, these covers are crafted from durable neoprene that shields your seats from spills, stains, and everyday wear and tear. They are engineered to be compatible with side impact airbags, ensuring safety without compromising protection. Installation is a breeze with no tools required, and the covers can be easily adjusted for a perfect fit using straps and hook-and-loop fasteners.

PARTS LIST:

Front Seat Cover Set

Rear Seat Cover Set

REQUIRED TOOLS:

No Tools Required

READ ALL SAFETY MESSAGES AND UNDERSTAND ALL

INSTRUCTIONS BEFORE ATTEMPTING TO INSTALL THIS

PRODUCT. ALWAYS WEAR SAFETY GLASSES DURING INSTALL.

Custom Neoprene

Seat Covers

Installation Manual:

For 2018 - Current Jeep Wrangler JL Vehicles #14167.40XX

For 2020 - Current Jeep Gladiator JT Vehicles #14167.41XX

DD_JL_SEAT_CVR_14167_40XX_A4.qxp_A4 6/29/20 2:06 PM Page 1

A hazardous situation which, if not avoided, could result in death or

serious injury. You CAN be KILLED or SERIOUSLY HURT if you don’t

follow instructions.

A hazardous situation which, if not avoided, could result in minor or

moderate injury. You CAN be moderately HURT and also may suffer

property damage if you don’t follow instructions.

Careful attention is required to this instruction or operation but does

generally not relate to personal injury. Damage to your

product or other property may result if you don’t follow instructions.

A Few Words About Product Safety:

Your Diver Down®seat covers are intended to protect your seats and enhance the

comfort and style of your vehicle’s interior. Before installation, please take a moment

to review the following safety information and installation instructions. Important

safety information is generally preceded by one of three signal words indicating the

relative risk of injury. The signal words mean:

Seat Covers Installation:

Prepare your seat covers for installation. Make sure to unbuckle all straps and unzip

all zippers on your seat covers prior to installation.

Remove front headrests by depressing the release tabs at the base of the headrest

posts and lift up on headrest.

Front seat covers are designed specifically for

the passenger and driver side of the vehicle and

are not interchangeable. The Diver Down sew

bar tags on front seats always face to the center

of the vehicle.

Start by slipping the seat cover over the back of your vehicle’s seat and pulling it

down all the way over seatback. Ensure that the holes for the headrest in the covers

line up with the grommets in the seat.

Tuck the connecting flaps of the seat cover between the seat base and seat back.

Folding the seat forward may make this process easier. Zip up all zippers on the seat

cover (if applicable). Attach the connecting flaps with the hook and loop fasters on

the back of the seat cover.

Install the seat bottom cover over the seat base and pass the connecting straps

between the seat back and seat base. Make sure the buckles and straps are tucked

all the way through the crevice between the seat back and base.

YOUR VEHICLE IS EQUIPPED WITH SIDE IMPACT AIRBAGS. MAKE SURE

THAT YOU INSTALL THE CORRECT SEAT COVERS FOR YOUR YEAR AND

MODEL. ALSO ENSURE THAT PASSENGER AND DRIVER SIDE SEAT COVERS

ARE INSTALLED ON THE CORRECT SEAT. FAILURE TO DO SO COULD

LESSEN THE EFFECTIVENESS OF THE AIRBAGS.

DD_JL_SEAT_CVR_14167_40XX_A4.qxp_A4 3/11/20 3:41 PM Page 2

Underneath the seat, connect and tighten the buckles and straps from the back of

the seat cover with the buckles at the front of the seat cover.

Pull the sides of the seat cover all the way down over the sides of the seat base. At-

tach the elastic straps with hooks to the buckled straps under the seats or to part of

the underside of the seat base.

Finish installation by adjusting the seat covers around and behind all seat levers,

adjusters, covers, and trim.

Seat covers can be carefully tucked under

and around the headrest grommets. This will

provide a more finished look and retain access

to headrest release tabs.

Finally, Install headrest covers and reinstall

headrests.

Product Care:

Periodic adjustments to the seat covers may be

necessary as the covers break-in and conform

to your vehicle’s seat. Seat covers can be spot

cleaned with mild soap and water and a soft

bristle brush. Do not machine wash.

Sunlight will naturally fade neoprene over time.

Seat covers are warrantied against defects in workmanship and materials, but not for

fading due to normal UV exposure. See next page for complete warranty information.

Further Information:

A Quadratec seat cover installation video is available @ www.quadratec.com

USE THE STRAPS FOR THE FINAL ADJUSTMENT ONLY. DO NOT PULL TOO

HARD OR OVER TIGHTEN THE STRAPS. THIS COULD CAUSE DAMAGE TO

THE SEAT COVERS.

DO NOT ATTACH STRAPS OR HOOKS TO ANY PART OF THE SEAT THAT

MIGHT IMPEDE OPERATION OF THE SEAT.

BEFORE DRIVING, TEST THE OPERATION OF THE SEATS. IF THE SEAT

OPERATION IS IMPAIRED BY THE COVER, MAKE ADJUSTMENTS TO THE

INSTALLATION OF THE SEAT COVER, AND TEST THE OPERATION OF THE

SEAT AGAIN. DO NOT DRIVE THE VEHICLE UNLESS THE SEATS

OPERATE PROPERLY.

Seat Covers Installation: continued

DD_JL_SEAT_CVR_14167_40XX_A4.qxp_A4 3/11/20 3:41 PM Page 3

Quadratec® Exclusive

One Year Limited Warranty

Your Quadratec®Diver Down®branded

accessories are covered by the following

Limited Warranty provided exclusively

by Quadratec, Inc., 1028 Saunders Lane,

West Chester PA 19380.

This Limited Warranty is the only warranty

made in connection with your purchase.

Quadratec neither assumes nor authorizes any

vendor, retailer or other person or entity to

assume for it any other obligation or liability in

connection with this product or Limited War-

ranty. This Limited Warranty does not apply

and is not cumulative to any accessory or part

distributed by Quadratec for which the Manu-

facturer provides a separate written warranty.

What is Covered: Subject to the terms, exclu-

sions and limitations herein and with respect

only to Quadratec branded accessories first sold

in the United States, Quadratec warrants to the

initial retail purchaser only that your

Quadratec accessory shall be free of defects in

material and workmanship: for a period of one

(1) years from date of retail purchase.

This Limited Warranty is not assignable and

shall terminate upon sale of the vehicle upon

which the Quadratec accessory is installed or

other transfer third persons.

All other warranties are hereby disclaimed, ex-

cept to the extent prohibited by applicable law

in which case any implied warranty of mer-

chantability or fitness for a particular purpose

on this product is limited to 1 year from date of

initial retail sale. Quadratec reserves the rights

to: (a.) require invoice or other proof your

accessory is within the terms of this Limited

Warranty as a condition of warranty service

and, (b.) make future revisions to this product

and Limited Warranty without prior notice or

obligation to upgrade your product.

What is Not Covered:

Your Quadratec Limited Warranty does not

cover products or parts Quadratec determines

to have been damaged by or subjected to:

(a.) installation damage, alteration, modifica-

tion, combination with other parts, failure to

maintain or improper repair or service, (b.) nor-

mal wear & tear, UV fading, cosmetic damage

or damage from moisture or water immersion,

(c.) Acts of God, accidents, misuse, negligence,

inadequate mounting or impact with vehicle(s),

obstacles or other aspects of the environment,

(d.) theft, vandalism or other intentional

damage.

Remedy Limited to Repair/Replacement:

The exclusive remedy provided hereunder shall,

upon Quadratec inspection and at Quadratec’s

option, be either repair or replacement of prod-

uct or parts (new or refurbished) covered under

this Limited Warranty. Customers requesting

warranty consideration should first contact

Quadratec to obtain a RGA number

(610-701-3336). All labor, removal, shipping

and installation costs are customer’s

responsibility.

Other Limitations - Exclusion of Damages -

Your Rights Under State Law:

In consideration of the purchase price paid, nei-

ther Quadratec nor any independent Quadratec

distributor/licensee are responsible for any time

loss, rental costs, or for any incidental, conse-

quential, punitive or other damages you may

have or incur in connection with any part or

product purchased. Your exclusive remedy

hereunder for covered parts is repair/replace-

ment as described above.

This Limited Warranty gives you specific rights.

You may also have other rights that vary from

state to state. For example, some states do not

allow limitations of how long an implied war-

ranty lasts and /or do not allow the exclusion

or limitation of incidental or consequential

damages, so the limitations and exclusions

herein may not apply to you.

Part #12999.3160 A4

DD_JL_SEAT_CVR_14167_40XX_A4.qxp_A4 3/11/20 3:41 PM Page 4

Diver Down Front and Rear Neoprene Seat Covers Installation guide

Brand: Diver Down

Model: Front and Rear Neoprene Seat Covers

Type: Installation guide

Download PDF

report

Diver Down Front and Rear Neoprene Seat Covers Installation guide

Diver Down Front and Rear Neoprene Seat Covers Installation guide

Related papers

Other documents