2. Oneida Air Systems
  3. VSRSLH000B

Oneida Air Systems VSRSLH000B Installation guide

  • Hello! I've analyzed the provided document detailing the Oneida Air Systems Retrofit Handle VSRSLH000. This product replaces the standard Hummel handle and offers improvements such as better dust collection, reduced maintenance, and longer sanding belt life. I'm ready to answer any questions you have about this product.
  • What does the retrofit handle replace?
    What is a benefit of this product?
    What are some improvements this handle offers for sanding?
    Does this handle eliminates the use of the dust bag?
Retrot
Handle
Hummel 8” Retrot
VSRSLH000
Improved collection at the oor.
Retrot handle replaces stock Hummel handle.
Machine stays cleaner, less maintenance.
Reduced dust jam-ups at the drum. Sanding belts last longer.
Entire cyclone ts within width of machine.
Clean operation. No airborne dust.
Eliminates cloth dust bag.
Appearance and color of Vortex subject to change.
Instructions:
- Remove Hummel handle from machine by loosening adjusting
screw on control rod & wing nut holding handle on machine.
Fig. 1 & 2.
- Loosen set screw that holds lift / lower controls in place. Un-
screw black handle opposite control rod and slide controls out
of stock Hummel handle. Fig. 3.
- Slide controls into OAS handle and tighten set screw. Fig. 4.
- Attach handle assembly to Hummel and tighten wing nut and
adjusting screw, making sure handle is bottomed out on machine.
- Attach emergency stop bracket to OAS handle. Fig. 5.
- Sander cyclone can now be attached to Hummel.
Before
After
/