Oneida Air Systems VSRSLH000B Installation guide

Retrot

Handle

Hummel 8” Retrot

VSRSLH000

Improved collection at the oor.

Retrot handle replaces stock Hummel handle.

Machine stays cleaner, less maintenance.

Reduced dust jam-ups at the drum. Sanding belts last longer.

Entire cyclone ts within width of machine.

Clean operation. No airborne dust.

Eliminates cloth dust bag.

Appearance and color of Vortex subject to change.

Instructions:

- Remove Hummel handle from machine by loosening adjusting

screw on control rod & wing nut holding handle on machine.

Fig. 1 & 2.

- Loosen set screw that holds lift / lower controls in place. Un-

screw black handle opposite control rod and slide controls out

of stock Hummel handle. Fig. 3.

- Slide controls into OAS handle and tighten set screw. Fig. 4.

- Attach handle assembly to Hummel and tighten wing nut and

adjusting screw, making sure handle is bottomed out on machine.

- Attach emergency stop bracket to OAS handle. Fig. 5.

- Sander cyclone can now be attached to Hummel.

Before

After