DRUM AMPLIFIER
Owner’s Manual
PROFESSIONAL DRUM AMPLIFIER
2
THE FCC REGULATION WARNING (for USA)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reason-
able protection against harmful interference
in a residential installation. This equipment
generates, uses, and can radiate radio fre-
quency energy and, if not installed and used
in accordance with the instructions, may
cause harmful interference to radio commu-
nications. However, there is no guarantee
that interference will not occur in a particular
installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment o and on, the user is encour-
aged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Unauthorized changes or modication to
this system can void the user’s authority to
operate this equipment.
CAUTION
The normal function of the product may
be disturbed by Strong Electro Magnetic
Interference. If so, simply reset the product
to resume normal operation by following
the owner’s manual. In case the function
could not resume, please use the product
in other location.
PRECAUTIONS
PLEASE READ CAREFULLY BEFORE PROCEEDING
Please keep this manual in a safe place for future
reference.
Power Supply
Please connect the designated Power Cord to an
AC outlet of the correct voltage.
Do not connect it to an AC outlet of voltage other
than that for which your instrument is intended.
Unplug the Power Cord when not using the instru-
ment, or during electrical storms.
Connections
Before connecting the instrument to other devices,
turn o the power to all units. This will help
prevent malfunction and / or damage to other
devices.
Location
Do not expose the instrument to the following
conditions to avoid deformation, discoloration, or
more serious damage:
Direct sunlight
• Extreme temperature or humidity
• Excessive dusty or dirty location
• Strong vibrations or shocks
• Close to magnetic elds
Interference with other electrical devices
Radios and televisions placed nearby may experi-
ence reception interference. Operate this unit at a
suitable distance from radios and televisions.
Cleaning
Clean only with a soft, dry cloth.
Do not use paint thinners, solvents, cleaning u-
ids, or chemical-impregnated wiping cloths.
Handling
Do not apply excessive force to the switches or
controls.
Do not let paper, metallic, or other objects into the
instrument. If this happens, remove the electric
plug from the outlet. Then have the instrument
inspected by qualied service personnel.
Disconnect all cables before moving the instru-
ment.
INFORMATION FOR YOUR SAFETY!
3
Panel Description
Front Panel ........................................................................................................ 4
Rear Panel ......................................................................................................... 4
Operation
Connections ..................................................................................................... 5
Turning on the Power ........................................................................................ 6
Placement ......................................................................................................... 6
Specications ...................................................................................... 7
Contents
Overview
This is a perfect monitor speaker to work with your digital drum sets. Equipped with 35
watts of power, it delivers a big and powerful sound of the input drum signals. You can
also use the convenient AUX Input to connect and play external music along with the
drums.
Feature
• The frequency response feature is optimized by enhancing the characteristics of
drum pads, to deliver a premium sound with strong bass.
• Two convenient knobs (BASS and TREBLE) allow you to adjust the low and high
frequencies of the drum sounds.
• The Aux Input provide additional exibility to play external music along with the
drums.
4
1. AUX IN jack: for connecting
external audio source, such as an
audio player.
2. BASS knob: for adjusting the
bass (low frequency) level.
3. TREBLE knob: for adjusting the
treble (high frequency) level.
4. INPUT1/2 jacks: for connecting the
drum module.
5. POWER switch: for turning the
power on or o.
Front Panel
1. Connect the speaker to the specied
power supply. Not using the specied
power supply may destroy the fuse.
2. If the speaker doesn’t work, rst unplug
the power cord, then check if the fuse
is destroyed. Always consult qualied
personnel to replace the fuse of the same
type.
3. To turn o the power, rst turn o the
speaker, then unplug the power cord from
the power outlet.
Note:
The speaker’s input sensitivity is set to a relatively high level so as to work with drum
modules which have low output level. If you are connecting to a sound source which has
high output level, distortion may occur if the volume level is set too high. Be cautious.
For connecting
the power cord
Fuse
Rear Panel
Panel Description
AC IN
F1AL250V
5
Connections
1. Connect the power cord to the AC IN jack on
the rear panel. Then plug the power cord to the
power outlet.
2. Use an audio cable to connect the drum module
to the INPUT 1 or INPUT 2 jack of the speaker.
Turn on the power of the speaker, then rotate
the volume knob to adjust the volume level.
INPUT 1 and INPUT 2 can be used interchange-
ably, for the convenience of connecting two
sound sources.
Note:
To prevent damaging the speaker and the
connected devices, always turn down the
volume and turn o the power of all units before
connection.
3. Use an audio cable to connect an audio player
to the AUX IN jack, you can play your favorite
songs along with the drums. Use the AUX IN
knob to adjust the volume level.
Notes:
1) If you’re using a connection cable with built-in
resistor, the volume level of the device connected
to the INPUT jack may become too low. If this
happens, use a connection cable without any
built-in resistor.
2) When connection is completed, turn on the
power of all devices in the specied order. If you
turn on the devices in the wrong order, you may
risk damaging the speaker and the connected
devices.
L
R
GND
Stereo input is
recommended
Operation
OUTPUT L
(MONO)
PHONES
OUTPUT
L+R
6
Turning on the Power
1. Make sure all volume knobs on the speaker and
the connected devices are set to “0”.
2. Turn on the devices connected to INPUT 1 and
INPUT 2.
3. Turn on the power of the speaker.
Note:
Before turning on the power, always turn down
the volume level. Even when volume level is set
to minimum, when turning on the power, you
may hear a sound. This is normal. It doesn’t
indicate any malfunction.
4. Adjust the volume levels of all devices.
Notes:
1) To turn o the power, rst turn o the speaker,
then unplug the power cord from the power
outlet.
2) The speaker has a protection circuit. When
the power is turned on, it will take a few sec-
onds before the speaker works normally.
Placement
When the speaker is working, make sure the
distance between the speaker and the wall is not
less than 20cm.
20 cm
or more
20 cm
or more
20 cm
or more
20 cm
or more
Operation
7
Power supply AC 220-240V 50/60Hz
Rated power output 35 W
Input impedance Input1: 100kΩ
Input2: 100kΩ
Input sensitivity Input1: -38dB
Input2: -38dB
EQ Bass: +/-10dB@60Hz
Treble: +/-10dB@10KHz
Aux In 3.5 mm (1/8-inch) stereo jack
Speaker Coaxial speakers (10-inch woofer, 1-inch tweeter)
Dimension 400 x 360 x 376 mm
Weight 13kg
Specications
AP33_OM07EN
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Medeli AP33 OM Owner's manual
- Type
- Owner's manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Electro-Voice EVOLVE-30M User manual
-
-
Boss Audio Systems BR-800 User manual
-
Yamaha QX-21 Owner's manual
-
Korg TRITON-Rack User guide
-
Yamaha DXR10 MKII User manual
-
Roland PM-30 User manual
-
Boss BR-800 Owner's manual
-
Roland PM-100 Owner's manual
-
Fractal Axe-Fx ULTRA User manual
