Page 1 of 1
Rev. 12-03-2010
Smarthome Limited Warranty – Smarthome warrants to original consumer of this product for a period of 2 years from date of purchase, this product will be
free from defects in material & workmanship & will perform in substantial conformity with its Owner's Manual. Warranty shall not apply to defects caused by
misuse or neglect.
U.S. Patent No. 7,345,998, International patents pending © Copyright 2010
Smarthome, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845
Quick-Start Guide
FilterLinc
Plug-In Electrical Noise Filter
Model: 1626-10 (10 Amps)
Introduction
Your new FilterLinc will prevent noisy electrical devices from
polluting onto power lines. FilterLinc will also stop INSTEON and
other power line carriers (PLC) signals from being absorbed and
trapped into your appliances. Includes an unfiltered pass-through
outlet. Safety tested and ETL approved.
Common devices that may interfere with your INSTEON or similar
power line-based automation system include:
Televisions, stereo components, satellite and cable
receivers
Computers, monitors, and accessories
Computer UPS (Uninterruptable Power Supplies)
Power strips
Power supplies for laptops and cell phones
Fluorescent and HID lighting
Motorized devices like refrigerators, pumps, or air
conditioners
Low-voltage lighting that uses lightweight, solid-state
transformers
Complete Instructions, Troubleshooting, and Tech Support
Owner’s Manual: www.smarthome.com/manuals/1626.pdf
Call:
INSTEON Gold Support Line at 800-762-7845
Unfiltered
pass-through outlet
Filtered outlet
Installing FilterLinc
FilterLinc should be installed between the offending device (noise-maker or signal-absorbing appliance) and your
home’s AC outlet.
1) Turn off the device to be filtered (i.e., TV or computer)
2) Unplug the device’s power cord from the outlet
3) Plug the cord into the outlet on the bottom of FilterLinc
4) Plug FilterLinc into an unswitched outlet
5) OPTIONAL: You may use the outlet on the front of FilterLinc as you would an ordinary uncontrolled outlet.
However, make sure the device you plug in does not harm INSTEON or other PLC signals.
It is usually recommended to avoid stacking INSTEON devices on pass-through outlets to prevent overheating. FilterLinc does not generate
heat, so it will not affect operation of the stacked INSTEON device. But be sure only one INSTEON device is plugged into the FilterLinc pass-
through outlet.
Now the device that was causing INSTEON transmission problems will be isolated from the AC lines, making your
home’s automation s
y
stem more reliable.
Testing an Electrical Device for Interference
If you suspect an electrical device might be interfering with INSTEON transmissions, use the following steps to
determine if the electrical device should be filtered.
1) Unplug the electrical device - don’t just turn it off
2) Retry sending INSTEON commands from the devices that are experiencing poor communications to determine if
they are working better
If the INSTEON devices begin working after the electrical device is unplugged, then install a FilterLinc on that
electrical device.
  • Page 1 1

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI