American Eagle
740 N. State Street
PO Box 169
Garner, IA 50438
800-392-3015
Fax: 641-923-9099
www.americaneagleacc.com
Installation Guide
American Eagle Mobile Drawer Sets
Manual Part No. 24265
Last Revision: 06/08/18
Subject to Change without Notification.
© 2018 American Eagle
Installation Guide
ii
PANEL SIDE LH RLT
PANEL SIDE RH RLT
SLIDE DRAWER
DRAWER WLDMT
PANEL SHELF
PANEL SHELF END
RIVET
DIVIDER ROLOT DRAWER
Nomenclature
Installation Guide
1
Installation Overview
Note: Drawers are removable. Pull the drawer full out, hang onto the latch, and gently tap
the bottom up. The drawer should pop out. This may aid in the installation process.
Step 1:
Compartment side and outer drawer side face
should be flush. This will allow the drawers to open
unobstructed by the compartment.
Step 2:
Push the drawer set tight to the back of the compartment. This allows for a 5/16-18 UNC cap
screw to be used to tie the drawer shelf to the back wall.
Step 3:
Extend the adjustable drawer shelf end tight to the front wall of the compartment. This allows for a
5/16-18 UNC cap screw to be used to tie the drawer shelf to the side wall. Repeat for other shelf
end if application allows.
Step 4:
Drill four(4) .344 holes for mounting of the drawer set to the floor of the compartment. Use 5/16-18
UNC cap screws to fasten drawer set to floor.
B
Installation Guide
2
A
Step 1:
Compartment side and outer drawer side face
should be flush. This will allow the drawers to
open unobstructed by the compartment.
Drawer shown in compartment.
Detail A
Compartment side and outer
drawer side face are flush
Step 2:
Push the drawer set tight to the back of the
compartment. This allows for a
5/16-18 UNC cap screw
to be used to tie the drawer shelf to the back wall.
Detail B
The drawer set is tight to the
back of the compartment.
Installation Details
Cap
Screw
D
Installation Guide
3
C
The drawer shelf is tight to
the front wall of the
compartment.
Step 3:
Extend the adjustable drawer shelf end tight to the front wall of
the compartment. This allows for a 5/16-18 UNC cap screw to
be used to tie the drawer shelf to the side wall. Repeat for
other shelf end if application allows.
Detail C
Step 4:
Drill four(4) .344 holes for mounting of the drawer set to the
floor of the compartment. Use 5/16-18 UNC cap screws to
fasten drawer set to floor.
Drill four holes into the
bottom of the compartment.
Detail D
Cap
Screw
Cap
Screw
Installation Guide
4
Note: The parts listed on this page are common to all
American Eagle Mobile Drawer Sets. For replacement
parts needed for your specific drawer set, please con-
tact Customer Service at
800-321-3741
Replacement Parts
.YTQNOITPIRCSEDTRAPMETI
1 19598 HANDLE (T) ROLOT DRAWER AH112 1
2 19599 LATCH SPRING ROLOT DRAWER 2
1HCTAL ELDNAH-T MAC589023
4 81810 NUT 0.38-24 HH JAM NYLOC 1
5 11754 RIVET SS 0.19X0.063-0.437 MGLP-U6-E 4
6 21039 CAP SCR #10-24X1.50 BTNHD SS 4
7 C4956 NUT #10-24 HH NYLOC SS 4
6
2
1
7
5
3
4
/
