AF Lighting 9121-FL Installation guide

Installation Instruction

Item No: 9120-FL & 9121-FL

1. Carefully unpack and take out the parts as picture shown.

2. Place the screw (B) through lock washer (C), iron washer (D), marble base (E), iron sheet (F) into the

steel pipe (G), then tighten the screw (B) with the wrench (A).

3. Place the wheel (H) through the steel pipe, and then place the screw (J) through the holes of the steel

pipe into the wheel (H) and tighten with screwdriver (K).

4. Screw the turn-knob (L) through steel pipe (G) into the wheel (H).

5. Place the steel shade (Q) through the steel globe (P) onto the socket (O), then secure with the socket

ring (R).

Note: Swing turn-knob (L) is only to adjust arm (I) up and down, not side to side. Swing wheel (M) is

only to adjust arm (N) side to side, not up and down.

Note: 120V/100W

This manual is also suitable for