2. Minka Lavery
  3. 72696-226

Minka Lavery 72696-226 Operating instructions

  • Hello! I've reviewed the installation instructions for the lantern model 72696. This document provides detailed guidance on how to safely and correctly install your new fixture, covering everything from preparing the site to connecting the wires and installing the bulbs. Feel free to ask me any questions you have about the installation process!
  • What should I do before starting the installation?
    What type of bulbs can be used?
    What should I do after connecting the wires?
Candle Sleeve #
CCV22105P-226
INSTALLATION INSTRUCTIONS
Model #72696
READ AND SAVE THESE INSTRUCTIONS
WAR N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E AK E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARING FOR INSTALLATION (Fig. 1)
1. Shut off the power at the fuse box or circuit breaker box and
remove the old fixture, including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts in
a clear area. Take care not to lose any small parts necessary
for installation.
3. Pull the black, white and ground wires out of base of the post
(A).
CONNECTING THE WIRES (Fig. 2)
4. While supporting the fixture, connect the electrical wires as
shown in Fig. 2. If your post has a ground wire (green or bare
copper), connect the fixture ground wire to it. If not, consult
your electrician for proper grounding (Fig.2). After wires are
connected, tuck them carefully inside the post cup (A) (not
included).
COMPLETING THE INSTALLATION (Fig. 1)
5. Align the lantern (D) with post (A) and secure with screws (B).
6. At this point, unscrew screws (C) and remove cage (F).
7. Install (4) four type B bulbs up to 60 watts or CFL or LED
equivalent (not included) in accordance with the fixture
specification. DO NOT EXCEED THE MAXIMUM WATTAGE
RATING! (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
8. Replace the glass shade (E) followed by cage (F) and secure
with screws(C).
Your installation is now complete. Return power and test the
fixture.
BARE COPPER(GROUND)
Fig.2
FIXTURE
WIRES
WHITE
BLACK
(HOT)
WIRES
HOUSE
GREEN OR
WHITE
(NEUTRAL)
WIRES
HOUSE
(GROUND)
COPPER
BARE
FIXTURE
WIRES
BLACK
WIRES
FIXTURE
GREEN OR
HOUSE
WIRES
\
“CAUTION-RISK OF FIRE CONSULT A
QUALIFIED ELECTRICIAN TO ENSURE
CORRECT BRANCH CIRCUIT CONDUCTOR”
ATTENTION – RISQUE D’INCENDIE, CONSULTER UN
ÉLECTRICIEN QUALIFIÉ POUR VOUS ASSURER QUE
LES CONDUCTEURS DE LA DÉRIVATION SONT
ADÉQUATS.
/