PASS FAIL
1. Any LEDs Red after 40 sec
1. All 3 LEDs Green after 40 sec
Page 8
1. Unplug the charger
2. Place Charger Test Pack in Charger
3. Plug in the charger
4. Observe 3 LEDs in the Test Pack
5. Cycle Power to charger (unplug and re-
plug)
Charger Test Pack Instructions
*Note: Use this Charger Test Pack Procedure to confirm that a
charger is OK. Step #5 is critical…the charger will not function
normally after the test until the main power is cycled.
-
1
