Removable Rear Bucket Seats
There are three types of rear bucket
seats:
RIGHT ONLY, CENTER
OR
LEFT,
and
LEFT ONLY. RIGHT
ONLY
and
LEFT ONLY
seats may be
equipped with the built-in child
restraint option.
The rear bucket seats can be removed to
provide extra storage. Each seat that
has the built-in child restraint option
fits in only one location in your vehicle,
but seats that don’t have the built-in
child restraint can be moved to different
floor locations. The back of each seat
has a diagram (similar to the one
above) that shows where the seat must
be located in your vehicle.
RIGHT ONLY
seats that don’t have
the built-in child restraint fit only in the
right locations.
LEFT ONLY
seats that
don’t have the built-in child restraint fit
only in the left locations. The
CENTER
OR LEFT
seat fits in the center location
and in either left location.
RIGHT
ONLY
seats that have the
built-in child restraint option fit only in
the rear set of floor pins in the right
location of the second row.
LEFT
ONLY
seats that have the built-in child
I
restraint option fit only in the rear set
of
floor pins in the left location of the
second row.
To
install third row seats, the second
row seats must be tilted forward or
removed. Don’t put the seats in the
wrong locations.
Entry to Third Row Bucket Seats
The
RIGHT
ONLY
seats have a lower
lever to tilt the seat forward.
To
get into
third row seats, push back the lower
lever on the
RIGHT ONLY
seat
nearest the sliding door and tilt the seat
forward. Then pull the seat back and
check that it locks into place.
0
15