MANUZOID
Explore
Explore
Bookmarks
Siemens
SN23E831TI/73
Siemens SN23E831TI/73 User manual
Type
User manual
Brand
Siemens
Size
1.86 MB
Category
Dishwashers
Pages
38
Language
English
Table of contents
Intended use
2
( Safety instructions
2
Safety instructions
2
Before you switch ON the appliance
2
Delivery
3
1. Check the packaging and dishwasher immediately for damage caused in transit. Do not switch on a damaged appliance, but contact your supplier.
3
2. Please dispose of the packaging material in an environmentally friendly manner.
3
3. Do not let children play with packaging and its parts. There is a risk of suffocation from collapsible boxes and film.
3
Installation
3
In daily use
4
Childproof lock (door lock)Door lock *
4
Damage
4
Disposal
4
1. Make redundant appliances unusable to prevent subsequent accidents.
4
2. Dispose of the appliance in a n environmentally friendly manner.
4
m Warning
5
Risk of injury!
5
m Warning
5
Risk of explosion!
5
m Warning
5
Risk of scalding!
5
m Warning
5
Risks to children!
5
7 Protection of the environment
6
Protection of the environment
6
Packaging
6
Old appliances
6
* Getting to know your appliance
7
Getting to know your appliance
7
Control panel
7
Appliance interior
7
+ Water softening system/Special salt
8
Water softening system/Special salt
8
Setting
8
1. Find out about the hardness value of your tap water. Your water utility company will help you with this.
8
2. Setting can be found in the water hardness table.
8
3. Close the door.
8
4. Switch on ON/OFF switch (.
8
5. Press and hold down the START button @.
8
6. Rotate programme selector 8 until the salt refill indicator ` flashes.
8
7. Release button.
8
To change the setting:
8
1. Rotate programme selector 8 until the required setting has been selected.
8
2. Press START button @.
8
Water hardness table
8
Using special salt
9
1. Open the screw-type cap of the compartment 1J.
9
2. Fill the tank with water (only required when switching on the appliance for the first time).
9
3. Then add dishwasher salt (not table salt or tablets).
9
Using detergents with salt componentDetergents with salt component
9
Switching off water softening systemSwitching off salt refill indicator/water softening system
9
m Caution
9
, Rinse aid
10
Rinse aid
10
1. Open the dispenser 1j by pressing and lifting the plate on the cover.
10
2. Carefully pour rinse aid up to the max. mark in the filler opening.
10
3. Close cover until it clicks shut.
10
4. To prevent excessive foam formation during the next rinse cycle, remove any rinse aid which has run over with a cloth.
10
Setting amount of rinse aid
10
1. Close the door.
10
2. Switch on ON/OFF switch (.
10
3. Press and hold down the START button @.
10
4. Rotate programme selector 8 until the rinse aid refill indicator X flashes.
10
5. Release button.
10
To change the setting:
10
1. Rotate programme selector 8 until the required setting has been selected.
10
2. Press START button @.
10
Switching off rinse-aid refill indicator
11
- Utensils
11
Utensils
11
Not suitable
11
Glass and utensil damage
11
Loading the dishwasher
11
1. Remove large food remnants. It is not necessary to prerinse utensils under running water.
11
2. Place the utensils so that
11
Unloading the dishwasher
11
Note
11
Cups and glasses
12
Pans
12
Tip
12
Cutlery basket
12
EtagereEtagere *
12
Folding spikesFolding spikes *
13
Small accessories holder *Small accessories holder
13
Knife shelf *Knife shelf
13
Adjusting the height of the basketAdjusting the height of the basket *
13
Appliance height 81.5 cm
13
22 cm
13
30 cm
13
24.5 cm
13
27.5 cm
13
27 cm
13
25 cm
13
Appliance height 86.5 cm
13
24 cm
13
33 cm
13
26.5 cm
13
30.5 cm
13
29 cm
13
28 cm
13
Top basket with side levers
14
1. Pull out the top basket 1" out.
14
2. To lower the basket, press in the left and then the right lever on the outside of the basket. In doing so, hold the sides of the basket along the upper edge to prevent it from suddenly dropping.
14
3. To raise the basket, hold the basket on the sides of the upper edge and lift it up.
14
4. Before re-inserting the basket again, ensure that it is at the same height on both sides. Otherwise, the appliance door cannot be closed and the upper spray arm will not be connected to the water circuit.
14
Top basket with upper and lower roller pairs
14
1. Pull out the top basket 1" out.
14
2. Remove the upper basket and re- attach it to the upper (stage 3) or lower (stage 1) rollers.
14
. Detergent
15
Detergent
15
Note
15
m Warning
15
Adding detergent
15
1. If the detergent dispenser 9" is still closed, press the lock 9* to open the detergent dispenser.
15
2. Close the cover on the detergent dispenser by sliding it up until the lock engages without difficulty.
15
Tip
16
Combination detergent
16
m Warning
16
m Warning
16
Notes
16
Overview of programmes
17
The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia.
17
Type of utensils
17
Type of soiling
17
Programme
17
Possible additional options
17
Programme sequence
17
Programme selection
17
Information for test institutes
18
0 Additional options
18
Additional options
18
Express Wash/ Speed Perfect (VarioSpeed)Ÿ Express Wash/ Speed Perfect/ (VarioSpeed) *
18
Ï Intensive zone *Intensive zone
18
· Hygiene *Hygiene
18
Half load§ Half load *
18
¿ Extra drying *Extra drying
18
1 Operating the appliance
19
Operating the appliance
19
Programme data
19
Aqua sensorAqua sensor *
19
Switching on the appliance
19
1. Turn on the tap fully.
19
2. Close the door.
19
3. Switch on ON/OFF switch (.
19
4. Rotate programme selector 8 to the required programme.
19
5. Press START button @.
19
Note
19
Timer programmingTimer programming *
19
1. Switch on ON/OFF switch (.
19
2. Keep pressing the Preselected starting time button H until the appropriate display 3h, 6h or 9h is lit.
19
3. Press START button @, timer programming is activated.
19
4. To delete the preselected starting time, keep pressing the Preselected starting time button H until none of the displays 3h, 6h or 9h is lit.
19
End of programme
20
Note
20
Interrupting the programme
20
1. Switch off ON/OFF switch (.
20
2. To continue the programme, switch on the ON/OFF switch ( again.
20
Terminating the programmeTerminating the programme (Reset)
20
1. Press START button @ for approx. 3 sec. until all displays go out.
20
2. The remaining programme sequence for draining the residual water takes approx. 1 minute.
20
Changing the programme
20
Intensive drying
20
1. Close the door.
20
2. Switch on ON/OFF switch (.
20
3. Press and hold down the START button @.
20
4. Rotate programme selector 8 until the “Check water supply” display h flashes.
20
5. Release button.
20
To change the setting:
20
1. By rotating the programme selector 8, you can switch on intensive drying (Dry display )" is lit) or switch off intensive drying (Dry display )" is not lit).
20
2. Press START button @.
20
2 Cleaning and maintenance
21
Cleaning and maintenance
21
Overall condition of the machine
21
m Warning
21
Health hazard
21
Special salt and rinse aid
21
Filters
21
1. After each washing cycle check the filters for residue.
21
2. Unscrew filter cylinder as illustrated and take out filter system.
21
3. Remove any residue and clean filters under running water.
22
4. Re-install filter system in reverse sequence and ensure that the arrow marks are opposite each other after closing the filter system.
22
Spray arms
22
1. Check outlet nozzles on the spray arms for blockages.
22
2. Unscrew the upper spray arm 1:.
22
3. Remove the lower spray arm 1B upwards.
22
4. Clean spray arms under running water.
22
5. Re-engage or screw on spray arms.
22
3 Fault, what to do?
23
Fault, what to do?
23
Note
23
m Warning
23
Waste water pump
23
m Warning
23
Risk of cuts!
23
1. First always disconnect the appliance from the power supply.
23
2. Take out top basket 1" and bottom basket 1b.
23
3. Remove the filters 1R.
23
4. Scoop out water, use a sponge if required.
23
5. Prise out the white pump cover (as illustrated) using a spoon. Grip the cover on the crosspiece and lift diagonally inwards. Remove cover completely.
23
6. Check impeller wheel and remove any foreign objects.
23
7. Place cover in the original position and press down until it engages (click).
23
8. Install filters.
23
9. Re-insert baskets.
23
Fault table
24
Fault
24
Cause
24
Remedial action
24
4 Customer service
31
Customer service
31
5 Installation and connection
31
Installation and connection
31
1. Checking appliance on delivery
31
2. Installing the appliance
31
3. Waste water connection
31
4. Drinking water connection
31
5. Electrical connection
31
Product package
31
Safety instructions
31
Delivery
32
Technical specifications
32
Installation
32
Waste-water connection
32
1. The required work sequence can be found in the installation instructions. If required, fit a siphon with an drainage connection.
32
2. Connect the waste-water hose to the drainage connection of the siphon with the enclosed parts.
32
Drinking water connection
33
1. Fasten the drinking water connection to the tap according to the installation instructions using the enclosed parts.
33
2. When replacing the appliance, always use a new water supply hose.
33
Electrical connection
33
Removing the appliance
34
1. Disconnect the appliance from the power supply.
34
2. Turn off the water supply.
34
3. Undo the waste water and drinking water connection.
34
4. Loosen fastening screws for the furniture parts.
34
5. If fitted, remove the base panel.
34
6. Pull out the appliance, carefully pulling the hose behind.
34
Transportation
34
Drain the appliance according to the following steps:
34
1. Turn on the tap.
34
2. Close the door.
34
3. Switch on ON/OFF switch (.
34
4. Select programme with the highest temperature.
34
5. Press START button @.
34
6. After approx. 4 minutes press the START button @ until all displays go out.
34
7. Switch off ON/OFF switch (.
34
8. Turn off the tap, disconnect supply hose and drain water.
34
Protection against frostProtection against frost (Emptying the appliance)
34
View document