saco Room Apartment Heating User manual

Operating Instructions – Apartment heating

• Open the flap on the right hand side of the control panel. You will see several buttons including

one named ‘Prog’

• There are 6 events all set up with different times and temperatures. You can customise these to

suit you.

• Press PROG once to move to Event 1. The time on the display screen will flash. If you want to

change the time use the + or - button to amend the time

• Then press the PROG button again to set the temperature you desire. The temperature on the

display screen will flash. If you want to change the temperature use the + or - button to amend it.

To get the heating effective set the temperature to 23 degrees or above

• Press PROG to move to Event 2. Follow the same process as Event 1 to move between the time

and temperature settings. Note that if you are happy with the pre-set time you don’t need to

press + or -, you just move on to the temperature setting by pressing PROG for a 2nd time

• Press PROG to move to Event 3 and continue the same steps until you get to the last event which

is Event 6. Once completed setting Event 6 press the button SET which will lock in all the changes

you have made to the 6 events

• As you move through each event on the display screen In the middle right side it will show which

event you are on displayed as P1/P2/P3/P4/P5/P6

Please be aware that as the heating is underfloor it doesn’t heat up immediately and does take

some time but once it’s up and running it is very effective.