KOZY KOLLAR KKPV-2 Installation guide

Type
Installation guide

This manual is also suitable for

Installation
New Construction & Remodeling
The only roof vent boot / flashing you install from INSIDE the building, OVER shingles, or similar roofing
materials which forms a weather tight seal for vent pipe penetrations. Patented and proven, the Kozy Kollar
utilizes three independent gasket systems that are designed to work in conjunction with each other to Keep out
the elements and Keeps You Off The Roof.
Step 1:From inside the building, square the template between the roof rafters. Cut the roof using a
reciprocating saw equipped with a rough-in blade. The downward pull of the blade will cut the shingles cleanly.
Step 2: Apply a thin bead of the sealant supplied with the Kozy Kollar into the Main Seal. With four of the
six threaded studs installed, pass the Kozy Kollar through the opening and position it on the shingles. The stud
will hold the Kollar in place.
Step 3: Install the two remaining studs, position the Lower Mounting Plates. Install the six rod coupling and
tighten to 8 ft. lbs.
JOBS DONE!
  • Page 1 1
  • Page 2 2

KOZY KOLLAR KKPV-2 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI